Abstract:Three different kinds of serpentine mineral samples were investigated using Fourier transform near-infrared spectroscopy (FTNIR). The results show that there are obvious differences in the characteristic infrared spectra of the three serpentine group minerals (lizardite, chrysotile, and antigorite), which can easily be used to identify these serpentine minerals. The combination of weak and strong peaks in the spectrum of lizardite appears at 3650 and 3690 cm−1, while the intensities of the peaks at 4281 and 4301 cm−1 (at 7233 and 7241 cm−1, respectively) are similar. A combination of weak and strong peaks in chrysotile appears at 3648 and 3689 cm−1 and at 4279 and 4302 cm−1, and a single strong peak appears at 7233 cm−1. In antigorite, there are strong single peaks at 3674, 4301, and 7231 cm−1, and the remaining peaks are shoulder peaks or are not obvious. The structural OH mainly appears as characteristic peaks in four regions, 500–720, 3600–3750, 4000–4600, and 7000–7600 cm−1, corresponding to the OH bending vibration, the OH stretching vibration, the OH secondary combination vibration, and the OH overtone vibration, respectively. In the combined frequency vibration region, the characteristic peak near 4300 cm−1 is formed by the combination of the internal and external stretching vibrations and bending vibrations of the structural OH group. The overtone vibrations of the OH stretching vibration appear near 7200 cm−1, and the practical factor is about 1.965. The near-infrared spectra of serpentine minerals are closely related to their structural differences and isomorphous substitutions. Therefore, near-infrared spectroscopy can be used to identify serpentine species and provides a basis for studies on the genesis and metallogenic environment of these minerals.

[In-Situ Raman Spectroscopic Study of Serpentine Using Diamond Anvil Cell].

A Raman spectroscopic study of phengite under high pressure

Serpentines, talc, chlorites, and their high-pressure phase transitions: a Raman spectroscopic study

High-pressure and high-temperature Raman study of cinnabar

In-situ Raman study and phase transition of gypsum under high pressure

Raman Scattering of 2H-Mos2 at Simultaneous High Temperature and High Pressure (up to 600 K and 18.5 Gpa)

In situ surface enhanced Raman spectroscopy detection in high pressure solution

Raman Spectra Based Pressure Calibration of the Non-Gauge Sapphire Anvil Cell at High Temperature and High Pressure

In Situ Raman Spectroscopic Study of Barite As a Pressure Gauge Using a Hydrothermal Diamond Anvil Cell

Research on the Raman Spectra of Gypsum at Pressure of 100~800MPa and Room Temperature

Isothermal Equation of State and Raman spectroscopy of Celestite

The Gem Anvil Cell: High-Pressure Behaviour of Diamond and Related Materials

Srb4o7:Sm2+: an Optical Sensor Reflecting Non-Hydrostatic Pressure at High-Temperature And/Or High Pressure in A Diamond Anvil Cell

High-Pressure Raman Spectroscopic Studies of Ulvospinel Fe2tio4

High Pressure Raman Spectra of Silicone Oil

High-pressure and High-Temperature Raman Spectroscopic Study of Hydrous Wadsleyite (Β-Mg2sio4)

Experimental study of Raman spectra of magnesite at 297 K and at the pressure of 0.13-1 GPa]

In situ Raman spectroscopic studies of FeS2 pyrite up to 675 K and 2100 MPa using a hydrothermal diamond anvil cell

Near-Infrared Spectroscopy Study of Serpentine Minerals and Assignment of the OH Group

[Raman Spectra of Carbonate Ions As Pressure Gauge at High Pressure and Room Temperature].

Dehydration Temperature of Serpentine at Elevated Temperatures and Pressures by Electrical Conductivity Method and Its Implications