Abstract:The linear fluorosilicone pentablock copolymers PDMS-b-(PMMA-b-PFMA)(2) are synthesized via two-step ATRP approaches by dimethylsiloxane (DMS), methyl methacrylate (MMA) and fluorinated methacrylate (FMA). Trifluoroethyl methacrylate (3FMA), hexafluorobutyl methacrylate (6FMA), octafluoropentyl methacrylate (8FMA) and dodecafluoroheptyl methacrylate (12FMA) are used as FMA. The effect of different fluorinated side chains on the surface properties of PDMS-b-(PMMA-b-PFMA)(2) films indicates that 3FMA, 6FMA and 8FMA behave the similar surface properties as lower water contact angles (theta(H2O)- 105-106 degrees) and higher surface free energy (26.83-27.55 mN/m) than P12FMA (theta(H2O)- 116 degrees, 19.52 mN/m) due to the competing migration between the PFMA and PDMS chains. Therefore, the effect of chloroform (CHCl3), tetrahydrofuran (THF), trifluorotoluene (TFT) and CHCl3-TFT solvents on the self-assembly and surface properties of PDMS-b-(PMMA-b-P12FMA)(2) film is investigated by DLS, TEM, SCA, XPS, SEM, AFM and QCM-D. A typical bimodal distribution with high content of micelles (310 nm, 93%) in CHCl3 solution and high content of unimers (17 nm, 70%) in CHCl3-TFT solution are formed, but a special unimodal distribution of unimers (15 nm) in THF solution and micelles (75 nm) in TFT solution are found. The micelles are confirmed by TEM as P12FMA core-PDMS/PMMA shell in CHCl3 solution, but PDMS core-PMMA/P12FMA shell in TFT and CHCl3-TFT solutions. The results reveal that the higher content of unimers contributes much to the fluorine-rich surface, higher cetane contact angle, lower surface energy and lower viscoelasticity for the film, but the higher content of micelles promote forming the roughness surface. Therefore, the most hydrophobic surfaces are the films casting from THF and CHCl3-TFT solution. (C) 2014 Elsevier B.V. All rights reserved.

Surface Microphase Separation in PDMS‐b‐PMMA‐b‐PHFBMA Triblock Copolymer Films

Microphase Separation Behavior on the Surfaces of Poly(Dimethylsiloxane)-Block-Poly(2,2,3,3,4,4,4-Heptafluorobutyl Methacrylate) Diblock Copolymer Coatings

Synthesis and Characterization of Poly(dimethylsiloxane)-Block-poly(2,2,3,3,4,4,4-heptafluorobutyl Methacrylate) Diblock Copolymers with Low Surface Energy Prepared by Atom Transfer Radical Polymerization

Preparation of Fluorosilicone Triblock Copolymers and Microphase Separation Behavior on Surfaces

Micro Separation Behavior of Pdms-Mdi-Peg Multiblock Copolymer Coating Surface

MICROPHASE SEPARATED STRUCTURES AND PROPERTIES OF PDMS-MDIPEG COPOLYMER SURFACE

Effect of annealing on the microphase separated behavior and properties of PDMS–MDI–PEG multiblock copolymer films

Microphase Separation of Poly(propylene Monothiocarbonate)-B-poly (ethylene Oxide) Block Copolymers Induced by Differential Interactions with Salt

Solvent-Induced Morphology of the Binary Mixture of Diblock Copolymer in Thin Film: the Block Length and Composition Dependence of Morphology

Studies on the Surface Morphology of Poly (Styrene-B-dimethylsiloxane) Copolymer Thin Films

Synthesis and Characterization of the Hydrophobic Diblock Copolymers of Poly(dimethylsiloxane)‐block‐poly(ethyl Methyl Acrylate) Through Atom Transfer Radical Polymerization

Composition and Solution Properties of Fluorinated Block Copolymers and Their Surface Structures in the Solid State

Microphase Separation Induced by Competitive Hydrogen Bonding Interactions in Semicrystalline Triblock Copolymer/homopolymer Complexes

Microphase Separation and Crystallization Behaviors of Bi-Phased Triblock Terpolymers with a Competitively Dissolved Middle Block

Synthesis and Surface Properties of a Fluorosilicone Triblock Copolymer

Synthesis and Surface Characterization of Poly(methyl Methacrylate)‐block‐polydimethylsiloxane Copolymers from Macroazoinitiator

Interfacial Behaviors of PMMA-PEO Block Copolymers at the Air/water Interface

Effect of Side Chains and Solvents on the Film Surface of Linear Fluorosilicone Pentablock Copolymers

Self-assembled micelle and film surface of fluorine/silicon-containing triblock copolymer

Morphology of poly(styrene-block-dimethylsiloxane) copolymer films

Effect of Polymer-Substrate Interactions on the Surface Morphology of Polymer Blend Thin Films