Measurement of the thermal conductivity of nanofluids using a comparative interferometric method
S. Sahamifar,D. Naylor,T. Yousefi,J. Friedman
DOI: https://doi.org/10.1016/j.ijthermalsci.2024.108890
IF: 4.779
2024-01-20
International Journal of Thermal Sciences
Abstract:A new comparative interferometric method has been developed to measure the thermal conductivity of nanofluids. The thermal conductivity of Al 2 O 3 -water nanofluid is measured relative to deionized water by comparing the steady-state temperature field in the two fluids separated by a conductive barrier using a Mach-Zehnder Interferometer. The method is not restricted to nanofluids and could potentially be used to measure the thermal conductivity of any transparent fluid. Moreover, the method is almost independent of the thermocouple temperature measurement accuracy, with optical errors in the fringe gradients being the primary source of measurement uncertainty. The uncertainty in the relative thermal conductivity measurements is estimated to be ± 6 %. For comparison, the thermal conductivity obtained by this technique is compared to transient hot wire measurements. The reliability of the comparative method is also demonstrated by measuring the thermal conductivity of deionized water. Subsequently, the relative thermal conductivities of Al 2 O 3 -water nanofluids with the concentration of 0.02, 0.05, 0.08, and 0.11 wt% are attained by the two methods at room temperature. This range of concentrations is of interest because anomalously high thermal conductivity has been reported in previous interferometric studies. The results indicate that the thermal conductivity obtained from the comparative interferometric method agrees with the transient hot wire results to better than 2.3 %. Moreover, the thermal conductivity of water-based Al 2 O 3 nanofluids with a weight concentration of less than 0.11 % is the same as deionized water within the uncertainty of the measurement methods.
engineering, mechanical,thermodynamics