Abstract:The ductility of metallic materials is recognized to be significantly affected by stress state and strain rate. However, systematic investigations on the impacts of stress state and strain rate on ductile behavior are infrequent, and only a minority of fracture models can consider both effects concurrently. This work aims to systematically investigate the ductile response of Ti6Al4V alloy over a broad spectrum of stress states and strain rates and to propose a ductile model that incorporates the coupled influence of stress state and strain rate. First, five types of specimens were employed to obtain distinct stress states. Then, the fracture strain of material was ascertained for strain rate spanning from 10 −3 /s to 10 3 /s, stress triaxiality ranging from -0.7 to 0.4, and Lode angle parameter varying from -1 to 1 using a combined experimental-numerical method. It was found that over a broad spectrum of stress states, the relation between fracture strain versus stress state is not monotonic, and the fracture strain reduces as strain rate increases. Utilizing the experimental data, a novel ductile fracture model incorporating the stress triaxiality, Lode angle parameter and strain rate was established and embedded into the ABAQUS/Explicit through the user material subroutine VUMAT. Finally, a validation test was conducted to demonstrate the validity of the proposed model. The results indicate the satisfactory correlation between experiment and calculation for fracture displacement and fracture morphology, which illustrates that the proposed model can predict the ductile behavior across a wide spectrum of stress states and strain rates. This work provides a definite theoretical guidance for the optimization design and safety evaluation of Ti-6Al-4V alloy structural components.

Investigation of an updated continuum damage model in the DBTT region

An Updated Continuum Damage Model to Investigate Fracture Process of Structures in DBTT Region

Improved Ultra-Low Cycle Fatigue Fracture Models for Structural Steels Considering the Dependence of Cyclic Damage Degradation Parameters on Stress Triaxiality

Experimental and Fea Investigations on the Fracture Properties of Pipe Structures under Internal Pressure in Dbtt Region

Improved Discontinuous Deformation Analysis Method for Modeling Tensile Cracking in Quasi-Brittle Materials

Towards Fully Automatic Modelling of the Fracture Process in Quasi-Brittle and Ductile Materials: a Unified Crack Growth Criterion

A Cohesive Model-Based Nonlinear Discontinuous Deformation Analysis for Tensile Fracture in Geotechnical Materials

Progress in Complex 2d and 3d Cohesive Fracture Modelling Considering Random Heterogeneity

Coupled effect of stress state and strain rate on ductile fracture of Ti6Al4V alloy

A Unified Phase Field Damage Model for Modeling the Brittle-Ductile Dynamic Failure Mode Transition in Metals

A Study on Phase-Field Models for Brittle Fracture

Continuum damage mechanics modelling incorporating stress triaxiality effect on ductile damage initiation

Experimental and Theoretical Investigation of Size Effects on the Ductile/Brittle Fracture Toughness of A Pressure Steel

A phase field model for ductile fracture considering the strain rate, stress triaxiality and Lode angle parameter

Modified Gtn Model for A Broad Range of Stress States and Application to Ductile Fracture

Experimental and Numerical Investigation of Ductile Fracture of Carbon Steel Structural Components

A thermodynamically-consistent non-isothermal phase-field model for probing evolution of crack propagation and phase transformation

Analysis of Ductile Fracture by Extended Unified Strength Theory

Modeling of Ductile Damage and Fracture Behavior Based on Different Micromechanisms

Modelling the Brittle-Ductile Transition Temperature of Irradiated A508-3 Steel With CPFEM

Effects of the Cohesive Law on Ductile Crack Propagation Simulation by Using Cohesive Zone Models