Inhomogeneity of Texture, Tensile Property and Fracture Toughness of 7050 Aluminum Alloy Thick Plate

张新明,韩念梅,刘胜胆,宋丰轩,曾瑞林,黄乐瑜

DOI: https://doi.org/10.19476/j.ysxb.1004.0609.2010.02.006

2010-01-01

The Chinese Journal of Nonferrous Metals

Abstract:The texture distribution, tensile property and fracture toughness of 7050 aluminum alloy thick plate were investigated by optical microscopy, scanning electron microscopy, transmission electron microscopy, X-ray diffractometry, tensile and toughness tests. The results show that the microstructure,texture,tensile property and fracture toughness are inhomogeneous in different layers along the thickness direction. At the same thickness, the tensile property and fracture toughness show appreciable anisotropy. From the surface to the center, the average sizes of the coarse second phase particles and recrystallization grains increase. Near the surface of the plate,typical shear textures {111}110 and cube textures {001}100 are observed, while the center of the plate shows typical β fiber texture with a scattering of cube texture. The quarter layer of the plate seems to serve as a transition layer. From the surface to the center, the strength is inhomogeneous in the rolling direction and long transverse direction. The strength in the center is smaller than that on the surface of the plate. The strength and fracture toughness show appreciable anisotropy at the same thickness. The strength in the rolling direction is higher than that in the long transverse direction and the short transverse direction, and the fracture toughness in the L-T orientation is higher than that in the T-L and S-L orientations at the same thickness. The fracture mode in the L-T orientation is trangranular fracture, and in the S-L orientation the fracture mode is intergranular fracture. In the T-L orientation, the fracture mode is a mixed fracture, the fraction of the trangranular fracture is lower than that in the L-T orientation, and the fraction of the intergranular fracture is lower than that in the S-L orientation.