Abstract:This paper presents a novel interleaved soft-switching bidirectional snubberless current-fed full-bridge voltage doubler (dc/dc converter) for an energy storage system in fuel cell electric vehicles. A novel secondary modulation technique is also proposed to clamp the voltage across the primary-side switches naturally with zero-current commutation. It, therefore, eliminates the necessity for an external active-clamped circuit or passive snubbers to absorb the switch turn-off voltage spike, a major challenge in current-fed converters. Zero-current switching of primary-side devices and zero-voltage switching of secondary-side devices are achieved, which significantly reduce switching losses. An interleaved design is adopted over a single cell to increase the power handling capacity obtaining merits of lower input current ripple, reduction of passive components' size, reduced device voltage and current ratings, reduced conduction losses due to current sharing, and better thermal distribution. Primary device voltage is clamped at rather low-reflected output voltage, which enables the use of low-voltage semiconductor devices having low on-state resistance. Considering input current is shared between interleaved cells, conduction loss of the primary side, a considerable part of total loss, is significantly reduced and higher efficiency can be achieved to obtain a compact and higher power density system. Steady-state operation, analysis, and design of the proposed topology have been presented. Simulation is conducted over software package PSIM 9.0.4 to verify the accuracy of the proposed analysis and design. A 500-W prototype has been built and tested in the laboratory to validate the converter performance.

An Isolated Soft-Switching Bidirectional Buck-Boost Inverter for Fuel Cell Applications

Design and control of bi-directional DC/DC converter for 30kW fuel cell power system

Current-fed DC/DC Converter with Reverse Block IGBT for Fuel Cell Distributing Power System

Design and analysis of soft-switching isolated step-up/down DC–DC converter for fuel cell vehicles and EV battery charging applications

Soft-Switching Single-Stage Current-Fed Full-Bridge Isolated Converter for High Power Ac/Dc Applications

Soft-switching three-phase matrix based isolated AC-DC converter for DC distribution system

Novel Bidirectional Snubberless Naturally Commutated Soft-Switching Current-Fed Full-Bridge Isolated DC/DC Converter for Fuel Cell Vehicles

Novel Interleaved Bidirectional Snubberless Soft-Switching Current-Fed Full-Bridge Voltage Doubler for Fuel-Cell Vehicles

Soft-Switching Non-Isolated Current-Fed Inverter for PV/Fuel Cell Applications

Novel bidirectional snubberless soft-switching naturally clamped zero current commutated current-fed dual active bridge (CFDAB) converter for fuel cell vehicles

A Novel High-Gain DC-DC Converter Applied in Fuel Cell Vehicles

High Step-Up/Down Switched-Capacitor Based Bidirectional DC-DC Converter

Single-Switch, Wide Voltage-Gain Range, Boost DC-DC Converter for Fuel Cell Vehicles.

An Isolated Single Stage Buck-Boost Inverter

Three-phase interleaved high step-up boost converter with voltage multiplier for fuel cell power system

A High Step-Up DC to DC Converter under Alternating Phase Shift Control for Fuel Cell Power System

A Four-Phase Interleaved Buck-Boost Converter With Changed Load Connection for the Fuel Cell Activation

A ZVS Three-Port DC-DC Converter Based on Coupled Inductor for Fuel Cell Vehicle

Interleaved ZVT Boost Converters with Winding-Coupled Inductors and Built-In LC Low Pass Output Filter Suitable for Distributed Fuel Cell Generation System

An isolated soft-switching buck-boost converter utilizing two transformers and embedded bidirectional switches on secondary-side for wide voltage applications

Wide Input-Voltage Range Boost Three-Level DC–DC Converter with Quasi-Z Source for Fuel Cell Vehicles