Mechanical alloying of FeAl intermetallic powder for metal injection moulding process

Haixia Song,Yunxin Wu,Shuai Yuan,Qianming Gong,Randall M. German
DOI: https://doi.org/10.1179/174329009X434275
IF: 2.2281
2013-01-01
Powder Metallurgy
Abstract:The Fe-48 at.-% Al powder used for powder injection moulding (PIM) was prepared by mechanical alloying in a high energy planetary ball mill and subsequent vacuum annealing. The effects of stearic acid (SA) as the process control agent on powder characteristics were investigated using X-ray diffractometer, laser particle size analysis and scanning electron microscopy. The dependence of solvent debinding efficiency of PIM feedstock on the powder characteristics was also studied. The results indicate that a low SA content for ball milling helps to prepare near spherical, coarse powder particles that exhibit good solvent debinding efficiency. On the contrary, a high SA content leads to thin layered, small particles with poor PIM solvent debinding efficiency. An intermediate SA content such as 1 wt-% makes the ball milled powder combine the advantageous characteristics for PIM process.
What problem does this paper attempt to address?