Abstract:In order to solve the problem of excessive short-circuit current in the present power system, a fault current limiter has become a new type of power device with high demand and is one of the current research hotspots. The flux-coupling type superconducting fault current limiter (FC-SFCL) generates a current-limiting impedance through decoupling superconducting parallel inductance based on the circuit breakers’ fractional interruption. The principle is simple, and the impedance is low during normal operation. It can directly use the existing circuit breaker to open a short circuit that is much higher than its own breaking capacity. Thus, it can be used for large-capacity fault current limiting and effective failure breaking. This paper focused on exploring and studying the implementation scheme of practical products of FC-SFCL. Considering that the quenched-type parallel inductance can limit the first peak value of the fault current, a quenched-type improvement scheme was proposed. Then, an electromagnetic design method based on the simplified calculation of the number of parallel tapes was proposed, which simplified the design process and reduced the design difficulty of the quenched FC-SFCL. Taking a 10 kV/500 A/5 kA quenched prototype as an example, its electromagnetic design was completed, and the performances of the non-quenched and quenched schemes were compared. The results showed that, compared to the non-quenched structure, the technical economics of the quenched one were more prominent, and it can be used preferentially for engineering prototypes. This study about the scheme of the quenched FC-SFCL and its electromagnetic design method is useful for promoting the implementation of the current limiter engineering prototype.

Design for New Bridge High Temperature Superconducting Fault Current Limiter

Simulation and Analysis for New Bridge-Type High Temperature Superconducting Fault Current Limiter

Research of the Coupling Transformer in the New Bridge-Type Solid State Fault Current Limiter System

Design Of A Novel Bridge-Type Fcl And Its Application In Upfc

STUDY ON CONTROL SYSTEM OF THREE-PHASE SOLID STATE FAULT CURRENT LIMITER

Transient Electromagnetic Force Analysis of High Temperature Superconducting Fault Current Limiter

Design And Test Of High-T-C Superconducting Coils For A Three-Phase 10.5 Kv/1.5 Ka Fault Current Limiter

Study Of The Three-Phase Saturated Transformer Coupling New Bridge-Type Ssfcl

Research on a Novel Bridge-Type Fault Current Limiter and Its Control Strategy

Design of Saturated Coupling Transformer in a New Bridge-type Solid State Fault Current Limiter

Study on Magnetic-Shield-type Air-Core Transformer Coupling SSFCL

Design and Evaluation of a Novel Non-Inductive Unit for a High Temperature Superconducting Fault Current Limiter (SFCL) with Bias Magnetic Field

Development and Test of 10.5 Kv/1.5 Ka HTS Fault Current Limiter

Simulation Analysis and Experimental Tests of a Small-Scale Flux-Coupling Type Superconducting Fault Current Limiter

Electromagnetic Design And Performance Analysis Of A Flux-Coupling-Type Sfcl

Transient Simulation and Analysis for Saturated Core High Temperature Superconducting Fault Current Limiter

Design Improvement of Fault Current Limiter Based on High Coupled Split Reactor Considering the Impact of Internal Ground Fault

Investigations on Quench Recovery Characteristics of High-Temperature Superconducting Coated Conductors for Superconducting Fault Current Limiters

Application study of different superconducting fault current limiter in power system

Design and Verification Test of a Flux-Coupling-Type Superconducting Fault Current Limiter

Quenched Flux-Coupling Superconducting Fault Current Limiter Scheme and Its Electromagnetic Design Method