Abstract:Numerical simulation is an important method to study the penetration into targets. Distinct results may be acquired if different kinds of software are adopted. In this paper, three kinds of commonly-used softwares (LS-DYNA, ABAQUS and PAM-CRASH) were adopted to simulate the same series of penetration experiments. The simulation results were analyzed and the advantages and disadvantages of each kind of software were compared. The purpose of this work is to help the researchers and engineers to select the most suitable software. The results in this paper demonstrate that the calculation results of the three kinds of software are basically consistent with the experimental results. The simulation results of the flat-headed projectile are generally better than those of the hemispherical projectile. The residual velocity of the projectile and the plug velocity were simulated well using all of the three kinds of software. The calculated velocities by ABAQUS and PAM-CRASH are closer to the experimental results, and the average relative errors are generally lower than 15%. Moreover, the errors from most calculation results by PAM-CRASH are even less than 10%. However, for the deformation of the projectile, the calculation results of the three kinds of software are quite different from the experimental ones. There are other differences in the performance of the three kinds of software. For example, the ballistic limits calculated by ABAQUS and LS-DYNA are higher than the experimental results, while those by PAM-CRASH are lower. ABAQUS is most likely to report errors but is balanced by calculation time and effects. LS-DYNA has a low error rate and good robustness. The change of model parameters (such as mesh density, friction coefficient, contact stiffness, viscous damping coefficient, etc.) has little effect on its calculation results. PAM-CRASH is greatly affected by model parameters. The conclusion of this paper is based on the following conditions: the target material is Weldox 460E steel, the projectile is ARNE tool steel, and the impact velocity range is 180－450 m/s. However, it is also of guiding significance for the penetration problem simulation of other materials in this velocity range.

Research on Similar Conditions and Simulative Experiments of Exterior Ballistics for Low Trajectory

A law of similitude for ballistic target ground testing

Experimental investigation on interior ballistics of variable depth underwater launch system

Study on analogous experiment method for projectile penetration

Simulation of Interior Ballistic Performance for Multiple-Volley Gun

Consistency Research On Interior Ballistic Of Small Caliber Electrothermal-Chemical Launching

A Similarity Method for Predicting the Residual Velocity and Deceleration of Projectiles During Impact with Dissimilar Materials

Interior Ballistic Analysis for Non-Cooling Underwater Launched Missile

Random Simulation of Interior Ballistics Repetition

Simulation Analysis of Ballistic Trajectory of Projectile Based on Matlab

Comparative study of numerical simulations of projectile penetration into metal targets

Study Of The Bullet Position Measuring Model With Six Light Screens

Simulation of interior ballistic two-phase flow of storage propellant charge

A Study on the Ballistic Missile's Optimal Impulse Orbit Transfer in the Passive Ballistic Curve

Simultaneous Measure of Internal Ballistic Multiple Parameters

Interior ballistic two-phase flow model and its calculation for a mixed charge structure

Research on Interior Ballistic Mechanics of Electromagnetic Railgun

Identification Of Ballistic Parameters Based On Virtual Ballistic Trajectory Data From Firing Tables

Research on the application of high and low trajectory penetration model for ballistic missile simulation

Experimental Investigation on Underwater Trajectory Deviation of High-Speed Projectile with Different Nose Shape

Research on Abnormal Geometric Similarity Design Method of a Missile with Tail Rudder Model in High Speed Wind Tunnel