Development of A Multi-Scale Noise Reduction Algorithm for Cone-Beam Micro-Ct Using Fuzzy Logic-Based Anisotropic Filter

Zhiwei Tang,Guangshu Hu
DOI: https://doi.org/10.5405/jmbe.30.5.03
IF: 2
2010-01-01
Journal of Medical and Biological Engineering
Abstract:In micro-CT, smaller voxels require much higher dose to achieve adequate signal-to-noise ratio compared to conventional CT, thus, necessitating a method to reduce statistical noise and then to improve dose efficiency. We developed a method for multi-scale filtration of micro-CT data before reconstruction. The study aims are to increase the signal-to-noise ratio (SNR) of image data while at the same time maintaining image quality, in particular spatial sharpness of the images. In our approach, each projection is decomposed into successive sub-bands representing different levels of resolution from coarse to fine. Within each sub-band, pixels are distinguished into high-contrast regions (edges) and smooth regions using a fuzzy logic operation. Anisotropic filters are then used to adaptively smooth the image data. The degree of smoothing is controlled by the factor obtained by fuzzy logic operation. Both the fuzzy membership function and fuzzy rules are defined in such a way that the performance is optimized in terms of its robustness to noise. The potential of our algorithm was evaluated using phantom and clinical data. It was shown that SNR could be improved by a factor of 4 at the same radiation dose without loss of sharpness or introduction of new image artifacts. Alternatively, on the basis of clinical performance, our method shows that the radiation dose can be significantly reduced while at the same time maintaining the noise level and the image sharpness. Additionally, our approach can be extended to other imaging methods as an efficient tool for edge-preserving noise reduction.
What problem does this paper attempt to address?