Abstract:Electrohydrodynamic (EHD) jet printing is a highly effective technique for micro/nanoscale three-dimensional manufacturing. However, due to the complicated electrohydrodynamic mechanisms behind liquid deformation and jet emission, the printing process with remarkable droplet consistency and excellent controllability is still under investigation. In this work, a numerical analysis is conducted on EHD jet printing under constant and step change of electric voltages. We first examine constant-voltage-based pulsating EHD jet printing and explain the impacts of voltage on the regimes, deposited droplet volumes, and durations of the three key printing stages, namely cone formation, jetting, and jet/meniscus retraction and oscillation. After that, we carry out a comprehensive investigation on EHD jet printing under various step changes of voltages, while focusing on the jet behaviors at the voltage switch and after detaching from the Taylor cone. With the assistance of the electric field distribution, interface charge density, velocity fields, and very clear liquid motion images obtained from the numerical data, we fully inspect the pulsed printing processes and elucidate the influences of the pulse time, bias voltage, and peak voltage on the printing behaviors, durations of the three printing stages, and deposited droplet volumes. Finally, based on the obtained results, we make a comparison of the printing outcomes between these two techniques. The findings discovered in this work can be used for advancing the understanding and controlling methods of this complicated but very useful manufacturing technology.

Research on High-speed Big Character Dot-matrix Jet Machine Based on Control of Electromagnetism

Study on the Property and Driver Mode of High-Speed Dot-Matrix Pulse Jet Generator

The Design of High-Speed Powerful Solenoid Based on Giant Magnetostrictive Material and Analysis of Its Control Method

Modeling, Design and Control of High-Speed Powerful Solenoid Based on Giant Magnetostrictive Material

The Research on the Improvement of the Dynamic Output Characteristics of Giant Magnetostrictive Actuator

Automatic Control System of Printer for Hot Bloom

Machining principle for non-cylinder pin hole of piston based on giant magnetostrictive material

Research on Control Method for Machining Non-Cylinder Pin Hole of Piston

Design and Application of Distributed Control System for High Speed Paper Machine

Design, Modeling and Simulation of an Innovation Pneumatic High Speed On-off Valve Based on Giant Magnetostrictive Material

Control System Design of High Speed Industrial Zigzag Stitching Machine

Droplet Jetting of Piezoelectric Printhead and Corresponding Effect Factors

Investigation on the design of hydraulic high-speed punching press with a large press force and a long press stroke

Design of Low-cost Electronic Jacquard Controller

Design and Experiment of a Solder Paste Jetting System Driven by a Piezoelectric Stack

Research on the Register System Modelling and Control of Gravure Printing Press

Regulation of drop-on-demand e-jet printing based on minimum pulse width and critical frequency

Droplet Generation and Piezoceramic Actuation of A Jetting Inker

Numerical analysis of electrohydrodynamic jet printing under constant and step change of electric voltages

Design of Electromechanical Control System of EDM for Drilling Micro Nozzles

Injection of Viscous Micro-Droplet via Nozzle-Driven Piezoelectric Micro-Jet and Its Performance Control Method