Abstract:The experiments on x-ray backlighting of wire-array Z-pinch using X-pinches as x-ray sources were performed. A wire-array z-pinch was placed between the anode and the cathode. The anode plate was normally mounted on return-current rods, but here two of these rods were replaced by two X-pinches. In order to obtain two time-resolved images, we need to know the current division among the paralleled X-pinches and the return-current rods so as to choose right wires for these two X-pinches since the timing of the x-ray burst from an X-pinch is current and wire mass dependent. For this purpose the currents flowing through these two paralleled X-pinches were measured with two Rogowski coils. It was found that two currents are almost the same each other even though the diameter and material of the wires used for these two X-pinches are significantly different. In order to explain this phenomenon, a circuit analysis was carried out. An X-pinch was electrically equivalent to an inductor in series with a resistor. The impedance of an X-pinch was determined by measuring the current and the voltage of the X-pinch. The inductance of the X-pinch was assumed to be a constant and estimated by the calculation of the magnetic field based on the well-known Biot-Savart's Law. The voltage of the inductance was calculated with L'di/dt and subtracted from the measured voltage of the X-pinch. Then, the evolution of the resistance was determined and is consistent with the theory of electrical exploding wire. At the start of the current the resistance of the exploding wires is several tens of Ohms, one order of magnitude higher than the metallic resistance of the wires at room temperature, and then it falls down quickly to about 1Ω, which reflects the physical processes occurring in the electrical exploding wires, i.e., a current transition from the overheated and highly resistive wire core to the highly conductive plasma. The resistance is only a little bit lower than the impedance, indicating that the resistance predominates over the inductance in determining the voltage across the X-pinch. It seems no strong influence of the wires on the resistance, which may be explained by the fact that the current flows through the surrounding plasma rather than the metallic wires itself. It was concluded that the current is almost equally divided between two paralleled X-pinches even though the diameter and material of the wires used for these two X-pinches are significantly different. The reasons for this roughly equal division are that the resistance is dominant in the impedance of an X-pinch and there is no strong influence of the wires on the resistance.

Non-equilibrium radiation of aluminum wire array Z-pinch implosion

Conversion of electromagnetic energy in Z-pinch process of single planar wire arrays at 1.5 MA

X-ray Backlighting of Wire Expansion and Plasma Merging of Z-Pinch Load with 10-40Ka/wire

Kinetic Investigations of Nonlinear Electrostatic Excitations in Quantum Plasmas.

Physical Analysis for Designing Nested-Wire Arrays on Z-pinch Implosion

Preconditioned wire array Z-pinches driven by a double pulse current generator

X-ray Observations of Tungsten Wire Arrayz-Pinch Implosions on QiangGuang-1 Facility

Preliminary Experimental Results Of Tungsten Wire-Array Z-Pinches On Primary Test Stand

X-Pinch Radiography for the Radiation Suppressed Tungsten and Aluminum Planar Wire Array

Visualizing Magnetically Driven Converging Radiative Shock Generated in Z-pinch Foil Liner Implosion

X-Ray Backlighting of Developments of $X$ -Pinches and Wire-Array $Z$ -Pinches Using an $X$ -Pinch

Current Division Between Two Paralleled X-pinches

Mass Density Evolution of Wire Explosion Observed Using X-Ray Backlight

Laser Shadowgraphy Diagnostics for Insulated-Ordinary Mixed Planar Wire Array Z Pinches

Measurement of the mass density evolution of wire explosion using X-ray backlight

Optical Image Diagnostics of a Wire Array Z Pinch

Experimental Study of Surface Insulated-Standard Hybrid Tungsten Planar Wire Array Z-Pinches at "Qiangguang-I" Facility

Study of ablation phase in double-wire Z-pinch based on optical Thomson scattering

UV Laser Probing of Imploding Wire-Array Plasmas on the Angara-5-1 Facility

Behavior of exploding wires

Optical Imaging System for Wire Array Z-pinch on "Qiangguang-I"