X-ray Observations of Tungsten Wire Arrayz-Pinch Implosions on QiangGuang-1 Facility
Zhang Fa-Qiang,Li Zheng-Hong,Xu Ze-Ping,Xu Rong-Kun,Yang Jian-Lun,Guo Cun,Xia Guang-Xin,Chen Jin-Chuan,Song Feng-Jun,Ning Jia-Min,Wang Zhen,Xue Fei-Biao,Li Lin-Bo,Qin Yi,Ying Chun-Tong,Liu Guang-Jun
DOI: https://doi.org/10.1088/1009-1963/15/9/028
2006-01-01
Abstract:Z-pinch experiments with two arrays consisting, respectively, of 32 4-mu m- and 6-mu m-diameter tungsten wires have been carried out on QiangGuang-1 facility with a current rising up to 1.5MA in 80 ns. At early time of implosion, x-ray framing images show that the initial emission comes from the central part of arrays, and double clear emission rings, drifting to the anode and the cathode at 5 x 10(6) cm/s and 2.4 x 10(7) cm/s respectively, are often produced near the electrodes. Later, in a 4-mu m-diameter tungsten wire array, filamentation caused by ohmic heating is prominent, and more than ten filaments have been observed. A radial inward shift of arrays starts at about 30 ns earlier than the occurrence of the x-ray peak power for both kinds of arrays, and the shrinkage rate of emission region is as high as 1.7 x 10(7) cm/s in a 4-mu m-diameter tungsten wire array, which is two times higher than that in a 6-mu m one. Emission from precursor plasmas is observed in implosion of 6-mu m-diameter tungsten wire arrays, but not in implosion of a 4-mu m-diameter tungsten wire array. Whereas, in a 4-mu m-diameter tungsten wire array, the soft x-ray emission shows the growth of m=1 instability in the plasma column, which is caused by current. The reasons for the discrepancy between implosions of 4-mu m- and 6-mu m-diameter tungsten wire arrays are explained.