Abstract:In this paper,the basic equations of beam-wave interaction for designing the 220 GHz folded waveguide(FW)backward wave oscillator(BWO) are described.On the whole,these equations are mainly classified into small signal model(SSM),large signal model(LSM),and simplified small signal model(SSSM).Using these linear and nonlinear one-dimensional(1D) models,the oscillation characteristics of the FW BWO of a given configuration of slow wave structure(SWS) can be calculated by numerical iteration algorithm,which is more time efficient than three-dimensional(3D)particle-in-cell(PIC) simulation.The SSSM expressed by analytical formulas is innovatively derived for determining the initial values of the FW SWS conveniently.The dispersion characteristics of the FW are obtained by equivalent circuit analysis.The space charge effect,the end reflection effect,the lossy wall effect,and the relativistic effect are all considered in our models to offer more accurate results.The design process of the FW BWO tube with output power of watt scale in a frequency range between 215 GHz and 225 GHz based on these 1D models is demonstrated.The 3D PIC method is adopted to verify the theoretical design results,which shows that they are in good agreement with each other.

P2-18: The backward-wave oscillation research in high power broadband helical traveling wave tube

Enhancing Broadband Helix TWT Performance Using Hollow Electron Beam

Study of BWO Power Holes in Helix Traveling Wave Tubes

Backward-Wave Oscillation Suppression in High-Power Broadband Helix Traveling-Wave Tubes

The Investigation of a High Power Relativistic Backward Wave Oscillator

Simulation of Backward-Wave Oscillation in Helix Traveling Wave Tube under Permanent Periodic Magnetic Focusing

Design of Slow-Wave Structure and Beam-Wave Interaction Simulation for Helix Traveling-Wave Tube

16.5: The suppression of BWO power holes in the TWTs using the helix pitch taper method

Experimental Study of A High-Power Backward-Wave Oscillator Operating Far from the Upper Cutoff

Theoretical Models for Designing a 220-Ghz Folded Waveguide Backward Wave Oscillator

Numerical Simulation Research on High Power Terahertz Backward Wave Oscillator

Effect of Attenuator on BWO Start Oscillation Condition in a Helix Millimeter Wave TWT under Magnetic Focusing

Particle-In-Cell Simulations from a X Band Coaxial Relativistic Backward Wave Oscillator

Design and Analysis of an Overmoded Slow Wave Structure for High Power Terahertz BWO

Theoretical Investigation into an Ultra-Wideband Helix Traveling-Wave Tube

Beam-wave Interaction Simulation and Phase Calculation for Traveling Wave Tube

Linear Analysis of a Backward Wave Oscillator with Coaxial Slow Wave Structure

Study on the Increased Threshold Current in the Development of 220-Ghz Folded Waveguide Backward-Wave Oscillator

Calculations of 3-D Nonlinear Beam-Wave Interaction in Traveling Wave Tube with Dynamic Velocity Taper Helix

Experimental Advances in 220 GHz Sheet-Beam Traveling-Wave Tubes

Suppression of In-Band Power Holes in Helix Traveling-Wave Tubes