Abstract:Owing to their low cost and reduced power losses, floating bush bearings are extensively used in high-speed rotors. The advantages are mainly the result of the rotation of the bush. When shaft speed is within a low speed range, bush rotation speed increases linearly with shaft speed. However, the bush-to shaft speed ratio decreases sharply when the shaft speed reaches a certain range. The mechanism of this phenomenon is not completely clear yet, and a precise prediction method has not been established. The traditional theoretical model predicts that the speed ratio remains constant even when the shaft speed reaches the certain range. Some researchers have attempted to improve the prediction model by considering thermal effect on the assumption that a temperature increase decreases the viscosity of the inner oil film and consequently reduces the speed ratio. However, temperature rise alone is insufficient to induce that much drop of speed ratio. This paper focuses on the effect of air invasion flow in the inner oil film from the axial ends and evaluates the importance of air invasion and thermal effects. Computational fluid dynamics (CFD) modeling is adopted in this study because of its capacity to handle complicated calculation domain and calculate air-oil two-phase flow. Three series of CFD simulations with different models are conducted. These models consider the thermal effect (thermal model), the air invasion effect (air model), and the combination of the thermal and air invasion effects (hybrid model). CFD results of the different models are compared to weigh the importance of each effect. The CFD calculation indicates that a substantial amount of air invades the inner oil film when the shaft speed reaches a certain range. Speed ratio drop is not Caused by a single factor, but it is the result of the combination of the air invasion and thermal effects. Air invasion, which researchers previously ignored, plays a greater role than the thermal effect.

Flow Modeling of Oil Film on Bearing Chamber Wall at High-Speed

Emulation of Temperature Model of Oil Film Bearing

Investigation on sealing gap between ring gear and case in internal gear machines

Analysis of Circulation Characteristics and Heat Balance of High-Speed Rolling Bearing under Oil-Air Lubrication

Effects of oil-air lubrication methods on the internal fluid flow and heat dissipation of high-speed ball bearings

An Improved Dynamic Modelling for Exploring Ball Bearing Vibrations from Time-varying Oil Film

Experimental and Numerical Study of the Influence of Loading Direction on the Lubrication and Cooling of Self-Circulating Oil Bearing System Applied in Internal Gear Pumps

Modeling of Partially Wetting Liquid Film Using an Enhanced Thin Film Model for Aero-Engine Bearing Chamber Applications

Online monitoring of oil film thickness of journal bearing in aviation fuel gear pump

Analysis of Oil-Air Two-Phase Flow Characteristics inside a Ball Bearing with Under-Race Lubrication

Lubrication and stability analysis of nonlinear rotor-bearing system

Analysis of oil shedding and ligaments formation on bearing rotary elements

Experimental Investigation of Lubrication Oil Film Dynamics in a Typical Aero-Engine Bearing Chamber Environment

Experimental Investigation of the Oil Supply Layer in a Model Rolling Bearing

The Comparison Of Four Pressure-Thermal Models Of Oil Film Bearing With The Non-Newtonian And Temperature-Viscosity Effects

Lubrication performance analysis of sealing structures in rodless open cylinders

Simulation study on the performance of gap oil film lubrication under extreme working conditions of micro‐textured hydrostatic support

Prediction on Flow and Thermal Characteristics of Ultrathin Lubricant Film of Hydrodynamic Journal Bearing

Research on Flow Characteristics of Air-oil Two Phase Annular Flow for Oil-air Lubrication

Numerical Investigation for Characteristics and Oil–air Distributions of Oil Film in a Tilting-Pad Journal Bearing

Investigation Of Air-Oil-Thermal Distribution In Floating Bush Bearings