Abstract:A magnetorheological (MR) damper has been manufactured and tested and a non‐linear model is discussed. The parameters for the model are identified from an identification set of experimental data; these parameters are then used to reconstruct the force vs. displacement and the force vs. velocity hysteresis cycles of the MR damper for the hysteretic model. Then experiments are conducted on a three‐storey frame model using impact excitation, which identifies dynamic parameters of the model equipped with and without the MR damper. Natural frequencies, damping ratios and mode shapes, as well as structural properties, such as the mass, stiffness and damping matrices, are obtained. A semi‐active control method such as a variable structure controller is studied. Based on the ‘reaching law’ method, a feedback controller is presented. In order to evaluate the efficiency of the control system and the effect of earthquake ground motions, both numerical analysis and shaking table tests of the model, with and without the MR damper, have been carried out under three different ground motions: El Centro 1940, Taft 1952, and Ninghe 1976 (Tangshan Earthquake in Chinese). It is found from both the numerical analysis and the shaking table tests that the maximum accelerations and relative displacements for all floors are significantly reduced with the MR damper. A reasonable agreement between the results obtained from the numerical analysis and those from the shaking table tests is also observed. On the other hand, tests conducted at different earthquake excitations and various excitation levels demonstrate the ability of the MR damper to surpass the performance of a comparable passive system in a variety of situations. Copyright © 2003 John Wiley & Sons, Ltd.

Mechanics performance test of MR damper and its application in structural seismic response control

New magnetorheological damper and its application in semi-active control of structural seismic response

New Type Magnetorheological Damper And Its Application On Semi-Active Control Of Structural Seismic Response

Semi-active control of wind excited building structures using MR/ER dampers

Experimental Study on Semi-Active Control of Frame-Shear Wall Eccentric Structure Using Mr Dampers

Sliding-mode-based semi-active control for oscillations of structures

Design, Performance Test and Analysis on Magnetorheological Damper for Earthquake Mitigation

Experimental Study of the Semi‐active Control of Building Structures Using the Shaking Table

Experiment and analysis of torsional seismic responses for asymmetric structures with semi-active control by MR dampers

Experiment Investigation of Structural Seismic Control with MR Damper

Experimental and Analytical Studies on Stochastic Seismic Response Control of Structures with Mr Dampers

Comparative Studies of Semiactive Control Strategies for MR Dampers: Pure Simulation and Real-Time Hybrid Tests

Experimental Study on Torsional Response Control of Frame-Shear Wall Eccentric Structure Using MR Dampers

Experimental study of mr damper performance and its nonlinear mechanical model

Elastic-Plastic Dynamic Response Analysis On The High-Rise Structure Incorporated With Mr Damper

Experimental studies on nonlinear seismic control of a steel–concrete hybrid structure using MR dampers

Seismic Structural Control Investigations Using a Prototype Magnetorheological Shear Damper

Comprehensive nonlinear seismic performance assessment of MR damper controlled systems using virtual real‐time hybrid simulation

Elastic-plastic Dynamic Response Analysis on Frame Structure Incorporated with MR Dampers Based on the Member Model of System

Dynamic modelling and control of shear-mode rotational MR damper for mitigating hazard vibration of building structures

Experimental Investigation of the Seismic Control of A Nonlinear Soil-Structure System Using Mr Dampers