Abstract:RAIN1000Z1 is a high performance readout module we developed last two years. It is based on the ZYNQ architecture SOC chip from Xilinx and ZYNQ is the new architecture of FPGA with dual high performance ARM Cortex-A9 processors and high capacity programmable logic. We developed a series of readout system with the RAIN1000Z1 module based on ZYNQ architecture. For the crystal scintillator detectors, such as BC-501A liquid scintillator in a Teflon vessel we used for neutron background measurement in CJPL (China JinPing under-ground Lab) experiment, we developed a two channels 8-Bit 1GHz FADC readout system with RAIN1000Z1 module. With the two R1250 PMTs in the dual end of detector, the analog signals are send to FADC and the digital results is triggered and anticoincidence in the FPGA logic, the final triggered data is send to computer by gigabits Ethernet with ARM processor running Embedded Linux. HMCAD1511 from ADI is used for 8-Bit 1GSPS analog data converter, and the high speed, low jitter 1GHz clock is generated by LMK04803B from TI. With the benefit of high bandwidth and high performance inter connected HP bus between ARM processor (PS) and FPGA logic (PL), the FADC's data gathered by FPGA logic is buffered and transferred to the ARM processor's DDR3 SDRAM running at 1066MHz with CDMA function without many CPU time. The readout interface's data throughput can reach more than 600Mbps with gigabits Ethernet. In this paper, details of the hardware design and HDL design will be introduced.

Design of FPGA Driver for ARM-based Data Acquisition System in DBPM

FPGA Implementation of High-Speed Data Acquisition System for High-Resolution Millimeter Wave Radar.

Design of rf front end for cavity beam position monitor based on ics *

Design and Implementation of LCoS Display Driver System Based on FPGA

Design of Data Acquisition System for Micro-accelerometer Based on ARM and FPGA

An embedded single-board computer for BPM of SSRF

The Development of a New Digital BPM Processor

Design of Remote Information Acquisition and Transmission Device Based on ARM

Design of LXI Parallel Data Acquisition Module

Readout System with 2-Channel 8-Bit 1ghz Fadc Based on Rain1000z1 Zynq Module for Crystal Detector

FABLE-DTS: Hardware-Software Co-Design of a Fast and Stable Data Transmission System for FPGAs

Progress of Digital BPM Signal Processor

Design of IRFPA Image Acquisition and Disposition System Based on FPGA

The design and initial testing of the beam position measurement system in SSRF based on fully digital signal processing

A Design of Multiple DDR SDRAM Controllers Based on FPGA in a Seismic Data Acquisition System

FPGA based High Speed Data Acquisition System for High Energy Physics Application

Design of Multichannel High-speed Synchronous Data Acquisition System Based on Multi-FPGA and Distributed Control Strategy

Design and Implementation of ARM+DSP Structure

An SoC-based Platform for Integrated Multi-Axis Motion Control and Motor Drive

Design of GPS base-band processing platform based on FPGA and ARM

Ahb Compatible DDR Sdram Controller Ip Core for Arm Based Soc