Abstract:The theoretical results indicate that iced bundled conductors experience spatial gallop-ing due to wind-induced vibration, involving in-plane, out-of-plane, and torsional movements. To better understand the dynamic response of this behavior from an exper-imental perspective, an innovative experimental method has been proposed. The method can simultaneously measure the in-plane, out-of-plane, and torsional vibration signals of iced bundled conductors' galloping. A testing system was established, and the method is applied in the galloping experiment of continuous iced bundled conductors, validating some theoretical results. This paper describes the construction of a wide-aperture, low-speed wind tunnel suitable for testing the galloping of continuous iced bundled conduc-tors. A "cut-bury-glue" method was proposed to create a model of continuous iced bun-dled conductors effectively, along with a method for connecting subconductors to im-prove experimental precision. The tests utilized laser displacement sensors and wireless posture sensors, considering the installation and data collection characteristics of the sensors. Through signal conversion, error correction, and other technical methods, sim-ultaneous measurement of in-plane, out-of-plane, and torsional vibration signals was achieved. The spatial galloping behavior, changing with wind speed, exhibits limited-amplitude and synchronous characteristics. The participation of different modes shows elliptical orbital motion in single-mode galloping and "8" shaped orbital motion in cou-pled-mode galloping. These results are consistent with previous theoretical research, offering a new approach to studying iced bundled conductors' galloping.

Analysis on Conductor Galloping Track Monitoring of Transmission Line

Design of Intelligent Monitoring System in Galloping Power Transmission Line

Accurate Evaluation of Transmission Line Model at Higher Frequencies for Characterising Field-to-Wire Coupling of Coated Twisted-Wire Pair with a Grounded Conductor

Numerical approach to galloping of conductor

Umerical a pproach to g alloping of c onductor

Computer Simulation of Overhead Transmission Line Galloping

Analysis of Transverse-Torsional Coupling Galloping Trajectory of Iced Transmission Lines

Analysis of Iced Transmission Line Galloping and Effect of Anti-Galloping

Analysis of the galloping behaviour of an electrified railway overhead contact line using the non-linear finite element method

Grid Line Galloping Analysis Using Euler Angle Attitude Estimation Method

Simulations of the Controlling Effect of Interphase Spacers on Conductor Galloping

A simultaneous measurement method for multi-directional galloping of iced bundled conductors and its application in spatial galloping behavior

Urban rail track condition monitoring based on in-service vehicle acceleration measurements

Nonlinear Finite Element Analysis on Galloping of Ice-Coated Transmission Line

Study of Ground Vibration from Trains Caused by Track Irregularities

Investigation on Galloping of D-Shape Iced 6-Bundle Conductors in Transmission Tower Line

Galloping of iced transmission lines considering multi-torsional modes and experimental validation on a continuous model

Study on the Effect of Anti-galloping Device with Cubic Stiffness and Particle Damping

Research of the track irregularity spectrum of Shanghai high-speed transrapid demonstration line

Analysis on the Doppler Frequency Offset and Error Rate during the High-speed Running of Train

Spatial Galloping Behavior of Iced Conductors under Multimodal Coupling