Abstract:The mode of fuel management of the HTR-10 was studied, including the simulation of the fuel shuffling process and the measurement of the burnup, of a fuel element. The prior consideration was the design of the equilibrium state. Based on this the fuel loading of the initial core and the fuel shuffling mode from the initial core through the running-in phase into the equilibrium state were studied. The code system VSOP was used for the physical layout of the HTR-10 at the equilibrium state and in the running-in phase. For the equilibrium state, in order to lessen the difference between the peak and the average burnup, 5-fuel-passage-through-the-core was chosen for the fuel management. The average burnup of the spent fuel for the equilibrium core is 80 000 MWd t (-1), and the peak value of it is less than 100 000 MWd t (-1) when the burnup of the recycled fuel element is under 72 000 MWd t (-1). The mixture of fuel element and graphite element was used for the initial core loading, the volume fractions of the fuel and the graphite elements were 0.57 and 0.43, respectively. During the running-in phase, the volume fraction of graphite will decrease with the fresh fuel elements being loaded from the top of the core and the graphite elements discharged from the bottom of the core. The fuel shuffling mode is similar to that of the equilibrium state. The burnup limit of recycled fuel element is also 72 000 MWd t - 1 and the peak burnup is less than 100 000 MWd t (-1). Finally the core will be full of fuel elements with a certain profile of burnup and reaches the equilibrium state. According to the characteristics of the pebble-bed high temperature gas-cooled reactor, a calibrating method of concentration of (CS)-C-137 was proposed for the measurement of fuel burnup. (C) 2002 Elsevier Science B.V. All rights reserved.

Simulation of Oxidation in HTR-10 Core

Assessment of Graphite Oxidation in HTR-10

Numerical Simulation Of Graphite Oxidation In Htgr

The modeling of graphite oxidation behavior for HTGR fuel coolant channels under normal operating conditions

Oxidation Behavior of Graphite with Steam in Helium at High Temperature

Experimental Study on Oxidation of Graphite for Htr

Numerical Simulation of the Transient Graphite Oxidation Process Based on a Dynamic Mesh Method

Study on Model of Nuclear Graphite Oxidation

Transient Analysis of Nuclear Graphite Oxidation for High Temperature Gas Cooled Reactor

Analysis of fuel element matrix graphite corrosion in HTR-PM for normal operating conditions

SiC/SiO2 Coating on Matrix Graphite Spheres of HTR Fuel Element Produced by a Two-Step Pack Cementation/High-Temperature Oxidation Process

Study of Sic/Sio2 Oxidation-Resistant Coatings on Matrix Graphite for Htr Fuel Element

Nonuniform Oxidation on the Surface of Fuel Element in HTR

Study of Multi-Pebble Oxidation Process in High-Temperature Gas-Cooled Reactor

The Gasification Of Graphite Matrix In Pebble Bed Reactors

Oxidation Performance of Graphite Material in Reactors

Cfd Investigating the Air Ingress Accident for A Htgr Simulation of Graphite Corrosion Oxidation

Study of the Oxidation Behavior of Fine-Grained Graphite ET-10 by Combining X-ray Μct with Mercury Porosimetry

Numerical simulation of graphite oxidation in a stagnation flow

Fuel Management of the HTR-10 Including the Equilibrium State and the Running-in Phase

Oxidation Experiments and Kinetics Analysis of Nuclear Graphite ET-10 by Gas Analysis and Microstructure Observation