Abstract:Undrained cyclic loading patterns and consolidation states can significantly affect the deformation features of medium-dense saturated fine-grained sand. A series of undrained cyclic loading tests with different consolidation states, i.e., various mean effective consolidation stresses (p0), principal stress direction angles (α0), ratios (R0) of major and minor principal stresses, and relative magnitudes of intermediate principal stress (b0), were performed on saturated micaceous fine sand specimens with a relative density of 50% corresponding to a wide strain range in the order of 10−5 to 10−2. The patterns of cyclic axial, torsional, and axial–torsional combined loadings were applied in a hollow cylinder apparatus. The small-strain shear modulus G0, the reference shear strain γr, curves for shear modulus reduction G/G0, the damping ratio λ and Poisson's ratio υ with increasing strain were determined. The results of the cyclic axial–torsional combined tests showed a close relationship between G0, γr, and υ as well as the consolidation state parameters p0, R0, α0, and b0. The G0 and γr increased nearly linearly with increasing p0 and with decreasing α0 or b0. The υ is strain dependent and increases as the p0 decreases. Tests indicated that the reduction of G with increasing shear strain γ became more pronounced as p0 increased. The relationship for the G/G0 versus γ/γr was approximately independent of the cyclic loading patterns and the various values of parameters p0, R0, α0, and b0. A slight difference is noted between the damping ratios λt and λz, corresponding to vertical and torsional deformations. An empirical model was proposed for the dependence of the increase in damping ratio characteristics on the deviatoric strain.

Experimental Study on the Deformation Characteristics of Coarse-Grained Materials under Cyclic Loading

Deformation Characteristics of Coarse-Grained Materials During Cyclic Loading of Deviatoric and Spherical Stresses

Deformation Characteristics of Saturated Clay in Three-Dimensional Cyclic Stress State

Study Of Microstructures Of Soft Clay Under Dynamic Loading Considering Effect Of Cyclic Stress Ratio And Frequency

Cyclic Deformation Behaviour of Natural K 0 -Consolidated Soft Clay under Different Stress Paths

Deformation Behavior of Anisotropically Overconsolidated Clay under One-Way Cyclic Loading

Deformation Characteristics of Overconsolidated Clay Sheared under Constant and Variable Confining Pressure

Undrained deformation behavior of saturated soft clay under long-term cyclic loading

INFLUENCE OF CYCLIC CONFINING PRESSURE ON CUMULATIVE DEFORMATION BEHAVIOR OF OVERCONSOLIDATED CLAY

Experimental Study On Particle Breakage Of Carbonate Gravels Under Cyclic Loadings Through Large-Scale Triaxial Tests

Permanent Deformation Characteristics of Coarse Grained Subgrade Soils under Train-Induced Repeated Load

Deformation of overconsolidated soft clay considering initial shear stress and frequency

Long Term Cyclic Behavior of Unsaturated Granular Soils

Influence of Grain Gradation on Permanent Strain of Unbound Granular Materials under Low Confining Pressure and High-Cycle Loading

Stiffness Degradation and Plastic Strain Accumulation of Clay under Cyclic Load with Principal Stress Rotation and Deviatoric Stress Variation

The Influence of Undrained Cyclic Loading Patterns and Consolidation States on the Deformation Features of Saturated Fine Sand over a Wide Strain Range

Deformation Behavior of Coarse-Grained Soil as an Embankment Filler under Cyclic Loading

Strain Degradation Model for Anisotropic Soft Clay under Cyclic Loading

Strain and pore pressure development on soft marine clay in triaxial tests with a large number of cycles

Undrained Dynamic Behaviors of Saturated Clays under Compressive Stress Paths Considering Cyclic Confining Pressure

STUDY ON ACCUMULATIVE PLASTIC STRAIN MODEL OF SOFT CLAY UNDER CYCLIC LOADING