Abstract:The micro-mixing combustor exhibits the advantages of rapid and uniform mixing of fuel and air, high safety, and low emissions, showing broad prospects in the utilization of hydrogen energy. The micro-tube serves as a fundamental unit of the micro-mixing combustor. This paper places emphasis on the mixing mechanism of hydrogen and air in the micro-tube, conducting a thorough analysis of the mixing phenomena in micro-tubes with different geometric configurations using the large eddy simulation (LES) method. When employing the fuel single-hole vertical injection structure, the micro-tube jet in cross-flow (JICF) generates vortex structures similar to those in open-space JICF. The counter-rotating vortex pair (CVP) plays a crucial role in the mixing process, but its mixing ability in the jet direction is not strong enough, leading to lower fuel concentration near the wall and increased mixing deficiency. At higher fuel injection speeds, the fuel jet impacts the wall and wraps around it, enclosing the air and promoting mixing. Increasing the number of fuel holes to 2, under constant speed ratio, results in a phenomenon of mutually opposing fuel jets, squeezing the fuel to the sides of the micro-tube. This enhances the local near-wall fuel concentration and reduces mixing deficiency. However, when using 3 or 4 fuel holes, the jets no longer oppose due to reduced penetration depth, and poor diffusion of fuel near the wall remains the main reason for mixing deficiency. To improve near-wall fuel concentration, structures with the jet at a certain angle to the diameter are studied. Under the influence of the wall, CVP evolves into a single vortex, and the fuel rotates along the wall. When the jet is inclined at 45 degrees to the diameter, mixing deficiency rapidly decreases. It can achieve relatively ideal mixing effects, with fuel and air uniformly mixed downstream of the fuel hole at approximately 15 times the tube diameter.

Influence of Multi-Source Vortex Structure on the Mixing of Fuel/Air

The Effect of Swirling Injector Geometry on the Flow Dynamics of Precessing Vortex Core

Effect of Swirl Field on the Fuel Concentration Distribution and Combustion Characteristics in Gas Turbine Combustor with Cavity

Numerical Simulation for Effects of Venturi Tube on Swirling Flow Field

Computational Study of the Effect of Dual Air Swirling Injection on Turbulent Combustion of Kerosene–Air at a High Pressure

Influences of device for flame joint and flow stabilization on performance of trapped vortex combustor

Numerical Simulation of Effects of Venturi Tube Throat Diameter on Flow Field of Combustor

Measurements of Mixing Layers and Vortex Structures of the Strut-Induced Flow in a Scramjet Combustor with PIV and POD

Premixed Gas Mixing Performance of Lobe-Forced Mixer at Different Configurations

Effects of swirling motion on the cavity flow field and combustion performance

Numerical Investigation of H2/air Mixing Characteristics in Micro-Tubes with Different Geometric Configurations

The effects of swirl number on the combustion characteristics in an internally-staged combustor

Effect of Different Nozzle Arrangements on Combustion Flow Characteristics in a Swirl Coupling Multiple Direct Injection Combustor

Swirling, Reacting, Turbulent Gas-Particle Flow In A Vortex Combustor

Numerical investigation of inlet guiding ring effect on combustor flow field with multiple swirler structures

Characteristics of enhanced mixing induced by plate jet actuation in supersonic flow

Inlet Mach number ratio and static temperature ratio coupling effect on vortex structure characteristics downstream of the flameholder in subsonic–supersonic mixing flow

Numerical and experimental investigation of streamwise-vortex/fuel-plume interactions in a scramjet combustor

Effects of fuel injection on the combustion and emission performance of a trapped vortex combustor

Enhancing the mixing characteristics of multi-hydrogen jets in scramjet engines through the implementation of fuel injection strategies and vortex generator positioning

Interaction Between Self-Excited Oscillations and Fuel–air Mixing in a Dual Swirl Combustor