Abstract:Under some postulated accidental conditions, the secondary loop of the reactor needs to release its pressure for consequent system action. During the pressure relief transient, the residual fluid mixture of water and the steam will pass through the heat-exchange tubes of the steam generator and the live-steam pipeline, which decreases the steam generator pressure and the steam generator temperature due to taking the heat stored in the components away. The pressure and the temperature during the transient needs to be controlled to protect the steam generator from the potential damage. A 250 MWth high temperature gas cooled reactor is selected to evaluate this countermeasure effect during the pressure relief transient in this paper. A thermal-hydraulic system analysis code is used for modeling and simulating the pressure relief transient after the accident occurs. The temperature change of the fluid and the components in the steam generator are relative to the pressure relief transient, which is dominated by the design of pressure relief valve. Larger diameter of pressure relief valve will result in more intensive blown-down transient which causes faster pressure decrease and stronger heat transfer between the inside walls of the components in the secondary loop and the fluid. The designed pressure value where the pressure relief valve closes will affect the transient also. The designed pressure value dominates the time of the pressure relief transient which affects the amount of the fluid from the pressure relief valve. Different amount of the fluid will take away different quantity of heat from the components in the secondary loop of reactor. The pressure relief transients with a series of different diameter of pressure relief valve under some typical designed pressure value were simulated and compared. The results indicate that the pressure and the temperature of the steam generator during the pressure relief transient could be controlled effectively with reasonable design on the pressure relief system, which will provide protection and benefit for the steam generator after the postulated accident.

Transient Response Simulation of High Temperature Gas-Cooled Reactor with Helium Turbine for Secondary Inlet Temperature Change of Precooler and Intercooler

Analysis of Precooling Injection Transient of Steam Generator for High Temperature Gas Cooled Reactor

Dynamic response simulation for high temperature gas-cooled reactor with indirect closed brayton cycle

Study on Pressure Relief Transient for High Temperature Gas Cooled Reactor

Development and Primary Verification of A Transient Analysis Software for High Temperature Gas-Cooled Reactor Helium Turbine Power System

Analysis of Loss-of-Flow Accidents in Pre-Cooler and Inter-Cooler of HTR-10GT

Post-Test Analysis of Helium Circulator Trip Without Scram at 3 Mw Power Level on the Htr-10

Simulation And Analysis Of Helium Circulator Trip Atws Test At Full Power On The Htr-10

Transient Analysis of Active Residual Heat Removal Process for Htr-Pm

Thermohydraulic Transient Studies of the Chinese 200mwe HTR-PM for Loss of Forced Cooling Accidents

Accurate Simulation of Htgr Steam Generator for Pressurized Loss of Forced Cooling Accident

Study on pressure relief system design for high temperature gas cooled reactor

Thermal-hydraulic characteristics analysis of unprotected accident and protection control strategy for helium-xenon cooled reactor system

Thermal hydraulic analysis of a high-temperature gas reactor steam generator after loss of feed water accidents

Study on the Break Accidents of the Htr-Pm Primary Loop

ICONE15-10084 COMPARISON OF LUMPED PARAMETER MODELS OF HELICAL-TUBE PRECOOLER IN HTGR BRAYTON CYCLE

Analysis on blow-down transient in water ingress accident of high temperature gas-cooled reactor

Transient pressure analysis for the reactor core and containment of a HTGR after a primary loop pressure boundary break accident

CFD investigating the air ingress accident occurred in a HTGR_simulation of thermal-hydraulic characteristics

Assessments of Water Ingress Accidents in A Modular High-Temperature Gas-Cooled Reactor

Transient Analysis of Active Cooling Procedure of HTR Reactor Core