Abstract:A new lower tungsten divertor has been developed and installed in the EAST superconducting tokamak to replace the previous graphite divertor with power handling capability increasing from <2 MW m−2 to ∼10 MW m−2, aiming at achieving long-pulse H-mode operations in a full metal wall environment with the steady-state divertor heat flux of ∼10 MW m−2. A new divertor concept, ‘corner slot’ (CS) divertor, has been employed. By using the ‘corner effect’, a strongly dissipative divertor with the local buildup of high neutral pressure near the corner can be achieved, so that stable detachment can be maintained across the entire outer target plate with a relatively lower impurity seeding rate, at a separatrix density compatible with advanced steady-state core scenarios. These are essential for achieving efficient current drive with low-hybrid waves, a low core impurity concentration and thus a low loop voltage for fully non-inductive long-pulse operations. Compared with the highly closed small-angle-slot divertor in DIII-D, the new divertor in EAST exhibits the following merits: (1) a much simpler geometry with integral cassette body structure, combining vertical and horizontal target plates, which are more suitable for actively water-cooled W/Cu plasma facing components, facilitating installation precision control for minimizing surface misalignment, achieving high engineering reliability and lowering the capital cost as well; (2) it has much greater flexibility in magnetic configurations, allowing for the position of the outer strike point on either vertical or horizontal target plates to accommodate a relatively wide triangularity range, δ l = 0.4–0.6, thus enabling to explore various advanced scenarios. A water-cooled copper in-vessel coil has been installed under the dome. Five supersonic molecular beam injection systems have been mounted in the divertor to achieve faster and more precise feedback control of the gas injection rate. Furthermore, this new divertor allows for double null divertor operation and slowly sweeping the outer strike point across the horizontal and vertical target plates to spread the heat flux for long-pulse operations. Preliminary experimental results demonstrate the ‘corner effect’ and are in good agreement with simulations using SOLPS-ITER code including drifts. The EAST new divertor provides a test-bed for the closed divertor concept to achieve steady-state detachment operation at high power. Next step, a more closed divertor, ‘sharp-cornered slot’ divertor, building upon the current CS divertor concept, has been proposed as a candidate for the EAST upper divertor upgrade.

Analysis Of The East Cryogenic System Operational Modes

Fully Active Cooled In-vessel Components of EAST Tokamak

Power Balance Investigation in Long-Pulse High-Performance Discharges with ITER-like Tungsten Divertor on EAST

Advances in the Long-Pulse Steady-State High Beta H-mode Scenario with Active Controls of Divertor Heat and Particle Fluxes in EAST

Physics Design of New Lower Tungsten Divertor for Long-Pulse High-Power Operations in EAST

Stationary Small/No ELM H-mode Regimes for High-performance Steady-state Operations in EAST

Design of a New Temperature Compensating System for High Power Circulator of EAST LHCD System

Numerical analysis of the static performance of an annular aerostatic gas thrust bearing applied in the cryogenic turbo-expander of the EAST subsystem

Recent EAST Experimental Results and Systems Upgrade in Support of Long-Pulse Steady-State Plasma Operation

Design of the Onboard Cryogenic System for High-Temperature Superconducting Maglev Vehicle

Characteristics of the edge temperature ring oscillation during stationary improved confinement mode in EAST

Performance Predictions of Rf Heated Plasma in East

Design and operations of a load-tolerant ICRH system in Experimental Advanced Superconducting Tokamak

EAST Ion Cyclotron Resonance Heating System for Long Pulse Operation

Power Supply System of EAST Superconducting Tokamak

Operational Region and Sawteeth Oscillation in the East Tokamak

A Long-Life, High-Capacity and High-Efficiency Cryogenic System Developed for High-Tc Superconducting Magnet Applications

Numerical Analysis of Divertor Target Heat Load of I-modes in Comparison with H-modes of EAST

Characteristics of Edge-Localized Modes in the Experimental Advanced Superconducting Tokamak (East)

Overview of recent experimental results on the EAST tokamak

Remote cryogenic helium gas circulating cooling system for a 10-Mvar class HTS dynamic synchronous condenser