Abstract:Although Toyoura sand has been widely used as a standard material for physical model tests (particularly centrifuge model tests), its path-dependent stiffness degradation curves are rarely reported in the literature. This leads to difficulties in back-analyzing and understanding the physical tests involving significant changes in the direction of stress paths (such as unloading problems). In this study, path-dependent stiffness degradation curves of medium-dense Toyoura sand were determined by carrying out a series of stress-path triaxial tests, with local strain measurements. In the triaxial tests, four typical recent stress histories (changes of path direction = 0, 90, -90, and 180 degrees) were simulated. The measured small strain stiffnesses of Toyoura sand were then used to calibrate an advanced hypoplastic model that accounts for path-dependent soil stiffness at small strains. To justify the validity of the calibrated hypoplastic model and model parameters, a Type A numerical prediction and a centrifuge model test were carried out to simulate a typical unloading problem (i.e., excavation) in medium-dense Toyoura sand. Triaxial test results show that a 180 degrees reversal in the direction of the stress path increased the initial secant modulus of Toyoura sand by eight times. The path dependency of soil stiffness, however, vanished when the deviatoric strain exceeded 0.3%. The ground deformations (resulting from excavation) predicted by the numerical analysis show reasonable agreement with the measured data from the centrifuge test. This suggests the potential applicability of the calibrated soil model and its model parameters in predicting or back-analyzing other physical model tests in Toyoura sand.

A Double Modified Plastic Work-Hardening Constitutive Model for Sand under Plane-Strain Conditions

Hypoplastic Model for Sand under Multidirectional Shearing Conditions Considering Fabric Change Effect

Failure Mechanisms of Sand under Asymmetrical Cyclic Loading Conditions: Experimental Observation and Constitutive Modelling

Hypoplastic Modeling of Anisotropic Sand Behavior Accounting for Rotation of Principal Stress Direction

Constitutive Modeling of Physical Properties of Coastal Sand During Tunneling Construction Disturbance

Unified Modeling of the Influence of Consolidation Conditions on Monotonic Soil Response Considering Fabric Evolution

Improved Lade-Duncan Model Based on SMP Criterion

AN ELASTOPLASTIC MODEL FOR SAND CONSIDERING DISTURBANCE

Cyclic accumulative deformation of sand and its explicit model

A refined deviatoric hardening plastic model for sand

Elasto-plastic constitutive modeling for granular materials

Three‐dimensional Anisotropic Plasticity Model for Sand Subjected to Principal Stress Value Change and Axes Rotation

Three-dimensional multi-mechanism bounding surface model for sands

Small Strain Path-Dependent Stiffness of Toyoura Sand: Laboratory Measurement and Numerical Implementation

An Elastoplastic Endochronic Constitutive Model for Soil Considering Multi-hardening Mechanisms

A Basic Constitutive Model for Sands

Elasto-plastic Model of Soil with a Function of Plastic Work As the Hardening Function

Constitutive Model for Sand Considering the Variation of Its Physical State

A Thermodynamic Constitutive Model for Saturated Sand

Constitutive model for soil with strain-softening behavior and its application in boundary value problems

A Unified Plasticity Model for Large Post-Liquefaction Shear Deformation of Sand