Abstract:Rockbursts were frequently encountered in the construction of deeply buried tunnels at the Jinping-II hydropower station, Southwest China. In those cases, the existence of large structural planes, such as faults, was usually observed near the excavation boundaries. The formation mechanism of the "11·28" rockburst, which was a typical rockburst and occurred in a drainage tunnel under a deep burial depth, high in-situ stress state and complex geological conditions, has been difficult to explain. Realistic failure process analysis (RFPA 3D ) software was adopted to numerically simulate the whole failure process of the surrounding rock mass around the tunnel subjected to excavation. The spatial distribution of acoustic emission derived from numerical simulation contributed to explaining the mechanical responses of the process. Analyses of the stress, safety reserve coefficient and damage degree were performed to reveal the effect of faults on the formation of rockbursts in the deep tunnel. The existence of faults results in the formation of stress anomaly areas between the tunnel and the fault. The surrounding rock mass failure propagates toward the fault from the initial failure, to different degrees. The relative positions and angles of faults play significant roles in the extent and development of surrounding rock mass failure, respectively. The increase in the lateral stress coefficient leads to the aggravation of the surrounding rock mass damage, especially in the roof and floor of the tunnel. Moreover, as the rock strength-stress ratio increases, the failure mode of the near-fault tunnel gradually changes from the stress-controlled type to the compound-controlled type. These findings were consistent with the microseismic monitoring results and field observations, which was helpful to understand the mechanical behavior of tunnel excavation affected by faults. The achievements of this study can provide some references for analysis of the failure mechanisms of similar deep tunnels.

Prediction on Surrounding Rock Splitting Failure Range of Baziling Forked Tunnel

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

COMPREHENSIVE STUDY ON PREDICTION OF ROCKBURST IN DEEP AND OVER-LENGTH HIGHWAY TUNNEL

Prediction on Surrounding Rock Splitting Failure of Underground Powerhouse in a Pumped-storage Power Station

Numerical Simulation Research on Rockburst Prediction of Gaoloushan Deep Tunnel Based on Strength-stress Ratio Method

Study on Splitting Failure Criterion of Surrounding Rock under Point Yield

Excavation Stress Path Induced Fracturing Mechanism of Hard Rock in Deep Tunnel

Discussion on Surrounding Rock Stress Induced Failure Mechanism in Deep Buried Tunnel

Evaluation of in-situ stress based on spalling behavior of hard rock mass

Stress Distribution and Stress-induced Failures in Surrounding Rock Mass of Deep Tunnels

Surrounding rock instability mechanism for fault-crossing tunnels in water-rich soft rock

Analysis of Extent of Deformation Range and Failure Characteristics of Rocks Surrounding a Tunnel Crossing Fault Zone Based on FDEM

Numerical simulation of splitting failure of Pubugou hydropower station based on energy method

Influence of Fault on the Surrounding Rock Stability of A Tunnel: Location and Thickness

Prevention logic of rock burst for brittle rock under high geo-stress

Formation mechanism of rockburst in deep tunnel adjacent to faults: Implication from numerical simulation and microseismic monitoring

Failure mechanism and deformation prediction of soft rock tunnels based on a combined finite–discrete element numerical method

Numerical Simulation of Surrounding Rock Deformation and Grouting Reinforcement of Cross-Fault Tunnel under Different Excavation Methods

Modeling of the Effect of Excavation Mode on the Extent of the Anisotropic Zone Surrounding Deep Tunnels

Study on Rock Burst Prediction of Deep Buried Tunnel Based on Cusp Catastrophe Theory

Role of foliation occurrence and stress orientation on asymmetric failure in foliated rock tunnel: Insight from numerical simulation