Abstract:Fibre optic sensors offer a means for the real-time continuous measurement of temperature or strain in concrete structures. Backscattered light along a fibre optic sensing (FOS) cable is interrogated to record a frequency shift and this shift is typically translated into a physical parameter such as strain or temperature using a calibration factor. However, when the measured frequency shift is a response to a combination of mechanical, thermal or hygral (humidity) loadings it is difficult to decouple individual influences. This presents a challenge in complex materials such as concrete where the strain, temperature and moisture levels change concurrently during the fresh and hardened states. Furthermore, depending on the application, both short- and longer-term measurements are required. As such, not only is the influence of these physical factors of interest but also the time and spatial stability of the measured frequency, which is highly dependent on the FOS cable composition. To investigate this aspect, fibre optic cables commonly used for strain (three tight-buffered cables) or temperature (two loose-buffered cables) measurement were considered. The cables were subjected to mechanical or environmental exposure and interrogated using a high-resolution optical backscatter reflectometer. The exposure regimes included three temperature cycles with sustained steps from 10 °C to 60 °C and back to 10 °C and an increasing and decreasing humidity cycle with steps between 30 to 90% relH. These ranges were selected to be indicative of typical environments for concrete. The results showed that the calibration factors back-calculated from increasing and decreasing temperature or humidity cycles differed. The third temperature cycle results were found to exhibit the smallest differences between heating and cooling suggesting that temperature pre-conditioning prior to installation could be advantageous. For all the cables, a drift in the readings was observed over the duration (2.5 h for temperature and 30 h for moisture) of the sustained steps. The magnitude of the drift depended on the cable type and exposure condition. In addition, local frequency fluctuations along the cable were observed which would need to be taken into account if only a single point along the cable length was used for analysis. The obtained results highlight the importance of the cable selection to maximise the FOS measurement fidelity for a given parameter of interest.

Effect of Hydroxyl Group Upon Optical Fiber Sensors Used in Permanent Downhole

Study On Frequency Response Characteristics Of High-Temperature Fiber Optic Sensor Head

Growth of high-quality Y2O3–ZrO2 single-crystal optical fibers for ultra-high-temperature fiber-optic sensors

Hydrogen ingression of optical fiber cable in high pressure high temperature downhole environment

An optical fibre sensor for remotely detecting water traces in organic solvents

Experimental Research on A Reflective Optical Fiber Bundle Hydrogen Gas Sensor

Experimental Study on the Characterization of Aging Resistance Properties of Optical Cables in the Hydrogen-Containing Downhole Environment

Optical Fiber Hydrogen Sensor Based on the EVA/Pd Coated Hollow Fiber

The Impact of Liquids and Saturated Salt Solutions on Polymer-Coated Fiber Optic Sensors for Distributed Strain and Temperature Measurement

A Study on Extrinsic Fabry-Perot Interferometric Optical Fiber Hydrogen Sensor

Research Status and Development Prospect of Optical Fiber High-Temperature Sensors

Ultra-High Sensitive Fiber Optic Hydrogen Sensor in Air

Evaluation of in-situ optical loss of polyimide-coated optical fiber under hydrothermal environments

Hydrogen sensing performance investigations with optical heating and sensing element surface modification

Durability Optimization of Fiber Grating Hydrogen Sensor Based on Residual Stress

Spectroscopic Techniques and Hydrogen-Sensitive Compounds: A New Horizon in Hydrogen Detection

Optics-mechanics Synergistic Fiber Optic Sensor for Hydrogen Detection.

Effect of high‐temperature, high‐pressure, and acidic conditions on the structure and properties of high‐performance fibers

Temperature and Humidity Stability of Fibre Optic Sensor Cables for High Resolution Measurements

Coating Effects of A Strain Sensor on Durability and Sensitivity Using the Fiber Loop Ringdown Spectroscopy Technique

Review of the Status and Prospects of Fiber Optic Hydrogen Sensing Technology