Abstract:In this paper, a model of flood area display and damageevaluation is discussed, which adopts seed spread algorithm to calculate and visualize flood area based on a DEM data set and under the condition of a given water level of flood. The raster image containing flood area is overlaid with raster data converted from thematic vector maps such as land-use map and related to other socio-economic data, and then quantitative evaluation of flood damage is achieved. There are two different cases, the so-called “non-source flood” and “source flood”, for determining flood area based on DEM and under the given water level condition. Non-source flood corresponds to the case with well-distributed and large-area rainfall where all the low-lying land may have a flood disaster, and in this case all the points with elevations below the given water level should be included in the flood area. The “source flood” is the case of flood (e.g. from bank burst) flushing through the surrounding lands that needs to consider “ci rculating” condition. Because flood may be obstructed by ring structures or high lands, thus it can only cover the place where it flows and reaches. One of the computer processing methods suitable for source flood is the seed-spread algorithm. The principle of this method is to select a representative pixel as a seed and to examine its contiguous pixels outward along 4 or 8 directions. The pixels, contiguous to it and meeting the given conditions, become seeds, and then contiguous pixels to the new seeds will be examined in the same way. This process repeats until an aggregation of the pixels which meet the given conditions on a certain plane are obtained. Adopting seed spread algorithm for source-flood area calculation is just to achieve an aggregation of pixels, which satisfies the connectivity requirement and the given conditions of water level. The initial position of seed pixel should usually be selected on the characteristic points, e.g. adjacent to a reservoir dam or stream boundary. The precision of flood area calculation is mainly determined by spatial resolution of the DEM, the area on the ground is represented by each pixel; whereas the accuracy of flood area calculation, to a great extent, is dependent on the preci sion of the DEM's pixel value or elevation.Once the area below the flood water level has been calculated, the flood damage evaluation can be calculated by overlaying the flood range with thematic maps and by relating to other socio-economic data. All thematic maps were converted to raster data because algorithm of the overlay analysis implemented in raster format is relatively simple and computing is fast. In order to improve accuracy of the flood damage evaluation it is necessary to accurately register and georefer all raster layers before overlay analysis. The calculation results of flood damage evaluation are generally represented by tabulation, which is a kind of classified statistics of flood damage data, e.g. a table representing total area of every land-use type in different administrative divisions. The results of flood area calculation and damage evaluation can also be visually and dynamically provided in the forms of graph, image, 3D or virtual reality. The model has been successfully applied in the “Zhejiang Provincial Water Conservancy Management System” developed for a national project.

Flood Disaster Evaluating Method Based on CCPSO along with Projection Pursuit Model and Its Application

Flood forecasting methods with precipitation prediction and multi-objective parameter optimization

A GIS Based Model for Calculating of Flood Area

A GIS-based Method for Flooded Area Calculation and Damage Evaluation

Modeling and Solving of Joint Flood Control Operation of Large-Scale Reservoirs: A Case Study in the Middle and Upper Yangtze River in China

Application of HSMAAOA Algorithm in Flood Control Optimal Operation of Reservoir Groups

Fast Comprehensive Flood Risk Assessment Based on Game Theory and Cloud Model Under Parallel Computation (P-GT-CM)

Multi-objective Stochastic Programming Model for Relief Allocation Based on Disaster Scenario Information Updates

Optimization of Reservoir Flood Control Operation Based on Multialgorithm Deep Learning

Urban flood risk assessment and analysis with a 3D visualization method coupling the PP-PSO algorithm and building data

Research on the evaluation of the resilience of subway station projects to waterlogging disasters based on the projection pursuit model

Coupled and collaborative optimization model of impervious surfaces and drainage systems from the flooding mitigation perspective for urban renewal

A novel integrated urban flood risk assessment approach based on one-two dimensional coupled hydrodynamic model and improved projection pursuit method

A multi-objective risk management model for real-time flood control optimal operation of a parallel reservoir system

Measurement and analysis of regional flood disaster resilience based on a support vector regression model refined by the selfish herd optimizer with elite opposition-based learning

Study on Optimal Operation of Reservoir Based on the Niche and Cross-Selection Operators'particle Swarm Optimization Algorithm

Ex-post evaluation analysis of flood control engineering system based on grey relation projection method

Application of Projection Pursuit Technology in Flood Forecasting

Multiobjective stochastic programming with recourses for real-time flood water conservation of a multireservoir system under uncertain forecasts

A simplified modeling approach for Optimization of urban river systems

Stochastic programming for floodwater utilization of a complex multi-reservoir system considering risk constraints