Abstract:Large-mode-area photonic crystal fiber is used to generate high power, high beam quality supercontinuum. Propagation and supercontinuum generation process of laser pulse in large-mode-area (LMA) photonic crystal fiber (PCF) is simulated by solving the general nonlinear Schrödinger equation (GNLSE) using the split-step Fourier method. Effects of the pump pulse parameters (peak power and chirp) and the length of photonic crystal fiber used on supercontinuum generation are particularly estimated. Nonlinear spectral broadening mechanism of laser pulse in large-mode-area photonic crystal fiber is discussed. The results show that the process of supercontinuum generation can be divided into three stages: initial broadening, dramatic broadening and saturation broadening. The spectrum width and efficiency can be achieved by the optimized length of LMA PCF to insure output of the generated supercontinuum at the dramatic broadening stage. The pump peak power and chirp have important impact on supercontinuum generation. When a small peak power pump is input, the spectrum broadens symmetrically. When the pump peak power increases, it brings little changes with the shorter wavelength component but broader of the longer wavelength component. The time-domain shape of the pulse exhibits concussion modulation as the effect of pulse breakup. When the pump chirp is positive, little influence is shown, except a shift of longer wavelength power by increasing the chirp. But the full width of the supercontinuum has little changes. While the pump chirp is negative and satisfy certain condition, the nonlinear is enhanced to facilitate the supercontinuum generation.

Broadly Tunable Ytterbium-Doped Photonic Crystal Fibre Laser and High Power Superfluorescent Fibre Source

All-Fibre Ytterbium-Doped Photonic Crystal Fibre Laser with High Efficiency

Yb3+-doped Large-Mode-area Photonic Crystal Fiber Laser with 210 W Continuous-Wave Output Power

A Widely Tunable Single-Longitudinal-mode Ytterbium-Doped Fiber Laser Based on Fiber Lyot Filter

Broadband tunable single-frequency Yb-doped fiber laser with dual ring subcavity and Sagnac ring filter

High-power tunable sub-nm narrowband near-diffraction-limited superfluorescent fiber source based on a single-lens spectral filter

High Efficiency Broad Bandwidth Erbium-Doped Superfluorescent Fiber Source

Broadband Supercontinuum Generation in PCF, HNLF and ZBLAN Fiber with a Carbon-Nanotube-based Passively Mode-locked Erbium-doped Fiber Laser

Supercontinuum generation and control from large-mode-area photonic crystal fiber

High-power single-stage thulium-doped superfluorescent fiber source

High-power all-fiber superfluorescent source with fused angle-polished side-pumping configuration.

All Fiberized Supercontinuum Laser Source Based on “figure of Eight” Cavity Modelocked Yb Fiber Laser

A Quasi-Three-Level Acousto-Optics (AO) Q-Switched Yb-Doped Double Clad Photonic Crystal Fiber Laser

Self-phase modulation enabled, wavelength-tunable ultrafast fiber laser sources: an energy scalable approach.

An Experimental Study Of Ultrashort Pulsed Ytterbium-Doped Fibre Laser And Amplifier

Ultraflat, Monolithic, Highly Stable Supercontinuum Source Based on Fluorotellurite Fiber

High-energetic ultrafast fiber laser sources tunable from 920 to 1030 nm based on tapered photonic crystal fibers

Er3+/Yb3+ Co-Doped Fluorotellurite Glass Fiber with Broadband Luminescence

Broadband Mid-Infrared Supercontinuum Generation Using A Novel Selectively Air-Hole Filled As2s5-As2s3 Hybrid Pcf

Octave-spanning Spectrum Generation in Tapered Silica Photonic Crystal Fiber by Yb:fiber Ring Laser above 500 MHz.

40 W picosecond fiber amplifier with the large mode-area polarized crystal fiber