Abstract:The structure of the hydrocyclone always changes with the application scene due to its excellent separation performance. A de-foulant hydrocyclone with a reflux ejector (DFHRE) has a completely different flow field structure from that of a conventional one. Under the effect of the reflux ejector, DFHRE has the function of overflow-suck-underflow to achieve continuous discharge and high separation performance. To further improve its separation performance, an inner conical surface was added to control the turbulence intensity, and the suction angle and vortex-finder insertion depth were adjusted to control the intensity of the overflow-suck-underflow. The single factor method and response surface method (RSM) were used to conduct experiments through general-purpose polystyrene particles (GPPS) water and sewage. The results show that the separation performance of DFHRE first increased and then decreased as the lengths of conical surface L-c and vortex-finder L-v increase, whereas the separation efficiency and the energy consumption changed monotonically with the increase of suction angle alpha. For the results of RSM, these three factors (L-c, alpha, L-v) had significant effects on maximizing separation efficiency and minimizing split ratio, whereas their combined effects were not significant. Finally, the maximum separation efficiency and minimum total pressure drop optimized by the RSM model are 94.62% and 1.09 kPa, respectively. The optimal values of L-c, alpha, and L-v was 0.29 (height ratio of inner conical surface to that of the outer cone), 30 degrees, and 0.50 (length ratio of the vortex-finder insertion to the total of cylinder-cone), respectively. Therefore, these three factors must be fully considered for designing DFHRE, and the insertion depth of the vortex-finder can exceed the interface of the cylinder and cone but not too much, which is different from that of the traditional hydrocyclone.

Design of Vinyl Chloride Dehydration-Type Hydrocyclone Based on Test Research

Progress on agitated apparatus for polymer devolatilization and its CFD simulation

Concentration Distribution of Droplets in a Liquid‐Liquid Hydrocyclone and Its Application

Enhancement of the classification and recovery process of fine mineral particles via a newly developed volute feed hydrocyclone

The coordinated relationship between vortex finder parameters and performance of hydrocyclones for separating light dispersed phase

Separation Characters of Dewatering Hydrocyclone with Annular Vortex Finder Based on Particle Image Velocimetry and Experiments

Study on velocity field in hydrocyclone model by PDPA measurement

DEVELOPMENT OF HYDROCYCLONE FOR SOUR WATER STRIPPER

Removal of coke powders in coking wastewater using a hydrocyclone optimized by n-value

Hydrodynamic Investigation of Ultraclean Wafer Drying Combining Marangoni Effect and Centrifugal Force

Experimental Study of De-Foulant Hydrocyclone Performance with a Conical Surface

Research on the particle circulation flow and classification performance of multi-stage cylindrical hydrocyclones

Design of an Axial Hydrocyclone for Preliminary Water Separation Using CFD, RSM, and SUS

Response Surface Method to Study the Effect of Conical Surface and Vortex-Finder Lengths on De-Foulant Hydrocyclone with Reflux Ejector

Cyclones of Different Sizes and Underflow Leakage for Aerosol Particles Separation Enhancement

Experimental study on separation of gypsum slurry hydrocyclone

Strengthened oil-water separation by swirl vane hydrocyclone based on short-circuit flow regulation

Study on Performance of a New Configuration of Circumfluent Hydrocyclone

Experimental study of the separation performance of a hydrocyclone with a compound curve cone

Research on a novel hydrocyclone for dense nonaqueous phase liquid separation

Experimental Study of A New Hydrocyclone for Multi-Density Particles Separation