Abstract:The failure of Hall sensors can give rise to loss of rotor position and speed information, which can result in loss of control of the speed loop, spatial decoupling errors, and affecting system stability in three-phase permanent magnet synchronous motor (PMSM) control system. To solve this problem, a Hall fault-tolerant control system based on sensorless state switching is proposed in this paper. Firstly, a three-phase PMSM control system based on field oriented control (FOC) is established to analyze and clarify the importance of rotor position and speed signals. Secondly, a detection scheme based on Hall change edge signal is designed to detect the health status of Hall sensors and implement fault-tolerant state switching. For the stability of the system, a sliding mode observer (SMO) is built to obtain the back electromotive force (back-EMF). In addition, the phase-locked loop (PLL) is designed to extract the rotor position and speed information from the back-EMF. When the system enters a fault-tolerant state, changes in the speed feedback loop can affect the control performance of the system. Therefore, the speed loop PI parameter optimization scheme based particle swarm optimization (PSO) algorithm is proposed to optimize the performance of the fault tolerant control system. Finally, the effectiveness of the fault-tolerant method based on the sensorless state switching after particle swarm optimization is verified on a semi-physical platform (RCP-HIL). The experimental results show that the Hall fault-tolerant control system proposed in this paper can effectively detect Hall sensor faults and cut into the fault-tolerant control state, and can maintain the control system stable during fault-tolerant state switching. Furthermore, the control system can maintain an observation error of $\pm 30rpm$ under variable load or variable speed conditions at medium and high speeds when the system enters fault-tolerant control state.

Fault-tolerant Inverter Permanent Magnet Synchronous Motor Position Sensorless Control System

Fault-Tolerant Control of Dual Three-Phase PMSM Based on Minimum Copper Loss under Multi-Phase Open and Open-Switch Faults

Fault-tolerant Control Strategy with Reduced Switching Frequency for Inverter-Based Fault in Open-Winding PMSM System

An Embedded Fault-Tolerant Control Method for Single Open-Switch Faults in Standard PMSM Drives

Position sensorless control of five-phase BLDC motor under single-phase open circuit fault

Fault Tolerant Inverter Based Direct Torque Control for Permanent Magnet Synchronous Motor

Sensorless control for five-phase PMSMs under normal and open-circuit fault conditions using super-twisting sliding mode observers

The Hall Sensors Fault-Tolerant for PMSM Based on Switching Sensorless Control with PI Parameters Optimization

Single- and Two-Phase Open-Circuit Fault Tolerant Control for Dual Three-Phase PM Motor Without Phase Shifting

Research on Fault Tolerant Inverter Based Permanent Magnet Synchronous Motor Direct Torque Control Drives

Study on Inverter Fault-Tolerant Operation of PMSM DTC

Control of Dual Three-Phase Permanent Magnet Synchronous Motor under Open Phase Fault Conditions

Sensorless control and start-up strategy of permanent magnet synchronous motor

Sensorless Control Strategy for Interior Permanent Magnet Synchronous Motors in the Full-Speed Section

Fault‐tolerant control of current residual vector three‐phase four‐switch motor drive system based on MLD model

Simplified PWM for Fault Tolerant Control of Open Winding PMSM Fed by Hybrid Inverter

Three-Phase Four-Switch Inverter Fed IPMSM Initial Position Estimation Based on HF Method

Open-Circuit Fault-Tolerant Control of a Six-Phase Asymmetric Permanent Magnet Synchronous Motor Drive System

Current sensor fault‐tolerant control strategy for surface‐permanent‐magnet‐synchronous motor drives based on improved full‐order sliding‐mode observer

Analysis on PWM Inverters Reliabilities and Novel Remedial Control Strategy for Fault-tolerant Topology

A fault-tolerant operation method of PMSM fed by cascaded two-level inverters