Abstract:With the advancement of multi-constellation and multi-frequency global navigation satellite systems (GNSSs), more observations are available for high precision positioning applications. Although there is a lot of progress in the GNSS world, achieving realistic precision of the solution (neither too optimistic nor too pessimistic) is still an open problem. Weighting among different GNSS systems requires a realistic stochastic model for all observations to achieve the best linear unbiased estimation (BLUE) of unknown parameters in multi-GNSS data processing mode. In addition, the correct integer ambiguity resolution (IAR) becomes crucial in shortening the Time-To-Fix (TTF) in RTK, especially in challenging environmental conditions. In general, it is required to estimate various variances for observation types, consider the correlation between different observables, and compensate for the satellite elevation dependence of the observable precision. Quality control of GNSS signals, such as GPS, GLONASS, Galileo, and BeiDou can be performed by processing a zero or short baseline double difference pseudorange and carrier phase observations using the least-squares variance component estimation (LS-VCE). The efficacy of this method is investigated using real multi-GNSS data sets collected by the Trimble NETR9, SEPT POLARX5, and LEICA GR30 receivers. The results show that the standard deviation of observations depends on the system and the observable type in which a particular receiver could have the best performance. We also note that the estimated variances and correlations among different observations are also dependent on the receiver type. It is because the approaches utilized for the recovery techniques differ from one type of receiver to another kind. The reliability of IAR will improve if a realistic stochastic model is applied in single or multi-GNSS data processing. According to the results, for the data sets considered, a realistic stochastic model can increase the computed empirical success rate to 100% in multi-GNSS as well as a single system. As mentioned previously, the realistic precision of the solution can be achieved with a realistic stochastic model. However, using the estimated stochastic model, in fact, leads to better precision and accuracy for the estimated baseline components, up to 39% in multi-GNSS.

Analysis of the Stochastic Characteristics for Medium and Long Baseline GPS Measurements

Study on Improving GPS Measurement Accuracy

Design and Analysis of a New GPS Algorithm

Real-Time Calibration Method For Ground-Based Tt&C Systems Using Satellite-To-Ground Differential Gps

Comparison of the stochastic model for GPS carrier phase measurements

Analysis of Multifrequency GNSS Signals and an Improved Single-Epoch RTK Method for Medium-Long Baseline

Estimating and Analyzing Long-Term Multi-GNSS Inter-System Bias Based on Uncombined PPP

Stochastic modeling of between-receiver single-differenced ionospheric delays and its application to medium baseline RTK positioning

Realization of Short Baseline Rapid Orientation Method Based on GPS Technique

Research on the Performance of Multi-GNSS Medium Length Baseline RTK with LEO-Augmented

On the Consistency of Stochastic Noise Properties and Velocity Estimations from Different Analysis Strategies and Centers with Environmental Loading and CME Corrections

Optimal selection of elevation-dependent stochastic models for real-time PPP with GPS/Galileo/BDS

Influence of stochastic modeling for inter-system biases on multi-GNSS undifferenced and uncombined precise point positioning

Empirical Stochastic Model of Multi-GNSS Measurements

Performance Analysis of Positioning Solution Using Low-Cost Single-Frequency U-Blox Receiver Based on Baseline Length Constraint

Stochastic modeling with robust Kalman filter for real-time kinematic GPS single-frequency positioning

Stochastic modeling of BDS2/3 observations with application to RTD/RTK positioning

Improvement of Multi-GNSS Precision and Success Rate Using Realistic Stochastic Model of Observations

A GNSS Baseline Network Adjustment Method Based on Length and Attitude Measurements

Long-Baseline Real-Time Kinematic Positioning: Utilizing Kalman Filtering and Partial Ambiguity Resolution with Dual-Frequency Signals from BDS, GPS, and Galileo

Performance evaluation of triple-frequency GPS/Galileo/BDS single-epoch medium baseline RTK positioning