Abstract:Organic light emitting diode (OLED) displays use red, green, and blue primaries with a higher saturation level to produce larger color gamuts than conventional liquid crystal displays (LCD). No past study, however, experimentally investigated how such a difference between these two display types causes color mismatch and observer metamerism using the most widely used color matching functions (CMFs)-the CIE 1931 2° CMFs-for color calibration and specification. In this study, 50 human observers performed color matching tasks for six color stimuli with a field-of-view of 4.77° between four test displays (i.e., one LCD and three OLED) and a reference OLED display. The color gamuts of the LCD and OLED displays were similar to the sRGB and P3 standard color gamuts. It was found the CIE 1931 2° CMFs cannot accurately characterize the color matches between the LCD and OLED displays, with different chromaticities required to produce matched color appearance. Particularly, when the stimuli had matched color appearance, the chromaticities of the stimuli produced by the LCD display were all shifted towards the -u'+v' direction in the CIE 1976 u'v' chromaticity diagram in comparison to those produced by the OLED display. This suggested that using the CIE 1931 2° CMFs for display calibration would cause the colors shown on OLED displays to have a yellow-green tint if those on LCD displays appear neutral. In addition, a larger degree of observer metamerism was found between the LCD and OLED displays, while little differences, in terms of color mismatch and observer metamerism, were found between the OLED displays. The CIE 2006 2° CMFs were found to have better performance than the CIE 1931 2°, 1964 10°, and 2006 10° CMFs, which could be partially due to the size of the stimulus used in the experiment.

P‐66: Measurement Comparison of Ambient Contrast for Liquid Crystal Displays

Display Measurement Using Imaging Color Luminance Meter and Its Uncertainty

CCD-based system for two-dimensional measurement of color uniformity of LCD projector

The New Process of Measuring Method for Luminance Contrast under Bright Room Condition

Impact Of Ambient Illumination Levels And Viewing Angles To Perceptual Contrast Ratio Of Display

Measurement and error analysis on color uniformity of LCD projector

Measurement and Correction System of Color Uniformity of Liquid Crystal Projection Display

Evaluation of Contrast Metrics for Liquid‐crystal Displays under Different Viewing Conditions

Testing Performance of CIECAM02 in Predicting Perceptual Contrast

Brightness Perceptive User Model Based on Simultaneous Brightness Contrast Phenomena

Color mismatch and observer metamerism between conventional liquid crystal displays and organic light emitting diode displays

P‐115: the Optimized Method for Sparkle Contrast Measurement of Anti‐Glare Covered Vehicle Display

Modelling and Modification of Simultaneous Lightness Contrast Effect Using the Albers' Pattern

Display Dimming Model Characterized By Three-Dimensional Ergonomic Study

P‐76: Origin and Improvement of LCD Reflectivity

Colour Appearance Comparison Between Lcd Projector And Lcd Monitor Colours

Methods to Improve Colour Mismatch Between Displays

Comparing The Quality Of The Led Based And Conventional Cie Illuminant Simulators

An Improved Surround Adaptive Metric For Dynamic Range Of Liquid Crystal Displays

A Comparison of Lightness Contrast Effects in CRT and Surface Colours

Color appearance comparison between LCD projector and LCD monitor colors