Abstract:Dimethyl carbonate (DMC) is a promising green chemical that plays a significant role in the sustainable chemical industry, clean energy technologies, and environmental protection. In response to the challenges of high equipment investment and energy consumption in the existing process for producing dimethyl carbonate through an ester exchange reaction using vinyl carbonate and methanol, a new reactive dividing-wall column (RDWC) process was developed. A new RDWC model was established by using Aspen Plus. The impact factors of reaction conditions such as reactant molar ratio, theoretical number of reaction stages, reaction pressure, and separation conditions such as theoretical number of common rectifying section, theoretical number of common stripping section, liquid phase distribution on both sides of the dividing wall, and side draw location were analyzed. A laboratory-scale new RDWC was designed and built referenced to the simulation results. The experimental research investigated key parameters affecting the reaction distillation column, such as the reaction zone height, reactant molar ratio, liquid phase distribution, reflux ratio, and vapor phase distribution on both sides of the dividing wall. This research laid the foundation for the scale-up designing of process parameters for the new RDWC. Under optimized conditions, the conversion rate of reactant EC (ethylene carbonate) exceeded 99.9%, the purity of methanol in the side draw was at least 99 wt %, and the purity of methanol ethylene glycol in the distillation column achieved a concentration greater than 99% (excluding the catalyst). The new method can greatly shorten the transesterification process (integrate the three towers in the original process into one) to produce dimethyl carbonate, save investment, and reduce energy consumption.

Process Simulation for Separation of Dimethyl Carbonate and Methanol Through Atmospheric-Pressurized Rectification

Dynamic Simulation and Control schemes of hybrid membrane-distillation process on ethylene- ethane system

Modelling and Simulation of Two-Bed PSA Process for Separating H2 from Methane Steam Reforming

Influence of Operating Conditions on the Hybrid Separation Process Used for C4 Etherified Products

Process optimization of CO2membrane and cryogenic hybrid separation

DESIGN OF INTEGRATED PROCESS OF DISTLLIATION AND PERVAPORATION FOR THE SEPARATION OF MTBE-C4-METHANOL MIXTURE

Hybrid process of distillation side-connected with pervaporation for separation of methanol/MTBE/C4 mixture

Liquid-phase CO2 Hydrogenation to Methanol Synthesis: Solvent Screening, Process Design and Techno-Economic Evaluation

Design and Control of Dimethyl Carbonate–Methanol Separation Via Pressure-Swing Distillation

Research on Rigorous Mechanism Modeling for Distillation Column Series under Wide Variation of Feed Condition

A Study on Process Simulation for the Carbon Dioxide Removal with MDEA

CFD Simulation for Separation of Carbon Dioxide-Methane Mixture by Pressure Swing Adsorption

Thermodynamic Model and Process Simulation for CO2 Removal with Low Temperature Methanol

Simulation of Process for Preparing Sodium Methoxide Using Aspen Plus

Large-scale Equation Oriented Dynamic Simulation of Ethylene Separation Columns

Extractive Distillation of Hydrocarbons with Dimethylformamide: Experimental and Simulation Data

Modeling and Design of a Multi-Tubular Packed-Bed Reactor for Methanol Steam Reforming over a Cu/ZnO/Al2O3 Catalyst

Study on a New Reactive Dividing-Wall Column for the Reaction of Vinyl Carbonate and Methanol Ester Exchange to Produce Dimethyl Carbonate

Simulation of extractive distillation process of ethyl acetate—n-hexane system using aspen plus

Mechanistic Analysis and Process Simulation of Ethyl Acetate-Ethanol Separation by Complex Solvent Extractive Distillation

Simulation and multi-objective optimization of the dimethyl carbonate production process