Abstract:The Euler–Lagrange method is a great way for multiphase bubble flow simulation, the detailed information of bubbles can be effortlessly obtained, and it is helpful for the efficiency and safety of different industry processes. Traditionally, the computational fluid dynamics-discrete bubble model (CFD-DBM) method has always been used to simulate this flow process. Nevertheless, the ability of the traditional CFD-DBM method is significantly limited in terms of the size ratio between the grid and bubble, where the grid size must be larger than the bubble size. In reality, the bubble may be larger than the grid and the grid/bubble size ratio can be very large due to the effects of complex bubble dynamics (such as the bubble breakup and coalescence) and complex internal flows. To address this issue, an improved CFD-DBM method is proposed in this study, which can be used for the simulation with a wide grid/bubble size ratio in gas–liquid–bubble multiphase simulation, and the volume of fluid (VOF) method is applied to capture the interface between gas and liquid phases. A gradient-based interpolation method is employed to reconstruct the liquid velocity around the target bubble when the grid size is much larger than the bubble size. If the bubble size is comparable with or larger than the grid size, the interphase force correction and the field smoothing will be carried out within a spherical support area. Subsequently, the proposed model is validated by the comparison with a bubble column experiment, in terms of the bubble size distribution and bubble vertical velocity. The results demonstrate the high accuracy of the new method. Finally, the influence of different parameters including normal spring stiffness, critical Weber number, and the range of the spherical support area on the bubble flow is investigated.

DEM-CFD Simulation of Fluidization Characteristics for Group Geldart′s A Particles under Couple′s Boundary Condition

CFD Simulation of an Agitated Gas-Fluidized Bed: Effects of Particle–particle Restitution Coefficient on the Hydrodynamics

Experiment and Numerical Simulation on Slug Fluidization of Geldart D Particles

Dynamic Modelling of Fluidisation in Gas-Solid Bubbling Fluidised Beds

CFD Simulation and Experiments of Dynamic Parameters in Gas–solid Fluidized Bed

Experimental Investigation of Bubble and Particle Motion Behaviors in A Gas-Solid Fluidized Bed with Side Wall Liquid Spray

Evolution and Fluidization Behaviors of Wet Agglomerates Based on Formation-Fragmentation Competition Mechanism

Cfd-Dem Investigation of Particle Elutriation with Electrostatic Effects in Gas-Solid Fluidized Beds

A Numerical Study on Gas-Fluidized Beds of Wet Flexible Fibers

Study on a Semi-Resolved CFD-DEM Method for Rod-Like Particles in a Gas-Solid Fluidized Bed

CFD-DEM Simulation of Fluidization of Polyhedral Particles in a Fluidized Bed

Particle-scale Simulation of Fluidized Bed with Immersed Tubes

CFD-DEM simulation of polydisperse gas-solid flow of Geldart A particles in bubbling micro-fluidized beds

Numerical Simulation of Two-Dimensional Spouted Bed with Draft Plates by Discrete Element Method

Direct comparison of CFD-DEM simulation and experimental measurement of Geldart A particles in a micro-fluidized bed

Investigating the fluidization of disk-like particles in a fluidized bed using CFD-DEM simulation

CFD-DEM Simulation of Clustering Phenomena in Riser and Downer

CFD-DEM Modeling of Rod-Like Particles in a Fluidized Bed with Complex Geometry

CFD-DEM Simulation of Fluidized Bed with an Immersed Tube Using a Coarse-Grain Model

CFD–DEM Study of Mixing and Dispersion Behaviors of Solid Phase in a Bubbling Fluidized Bed

An Improved Computational Fluid Dynamics-Discrete Bubble Model for Multiphase Bubble Flow Simulation with a Wide Grid/bubble Size Ratio