Styrene-Acrylonitrile Emulsion Copolymerization in the Presence of Polytetrafluoroethylene Seeds

Gaojun Xiao,Sheng Li,Yongzhong Bao,Zhiming Huang
DOI: https://doi.org/10.3969/j.issn.1001-7631.2010.01.012
2010-01-01
Abstract:Styrene(St) and acrylonitrile(AN) emulsion copolymerization in the presence of commercial polytetrafluoroethylene latex particles as the seeds were carried out, and influence of monomers adding policy, the composition and dosage of OP-10/sodium dodecylsulfate(SDS) composite emulsifier on the polymerization stability, average size and size distribution, and morphology of composite latex particles were investigated. It was found that the polymerization stability of semi-continuous emulsion copolymerization added with pre-emulsified monomers was better than that of batch emulsion copolymerization and semi-continuous emulsion copolymerization added with pure monomers. The mean size of PTFE-St/AN copolymer(SAN) composite latex particles was greater than that of PTFE seeds when the total dosage of OP-10 and SDS was lower than 4.0% mass fraction(based on monomers) and mass ratio of OP-10 to SDS in range of 1/2 to 2. When the total dosage of OP-10 and SDS was greater than 4.0%, the mean size of PTFE-SAN latex was lower than that of PTFE seeds due to the secondary particle formation of SAN. PTFE-SAN composite particles exhibited spherical shape with PTFE coated by SAN, while PTFE seeds exhibited rod or egg-like shape.
What problem does this paper attempt to address?