Abstract:Based on the Structure Oriented Lumping (SOL) method, a molecular-level reaction kinetic model for hydrocracking process was established to investigate the reaction laws of polycyclic aromatic hydrocarbons (PAHs) and heteroatomic compounds in hydrocracking process and calculate the molecular compositions of hydrocracking products. Molecules showed different reaction laws due to the differences of the initial contents, the structural increments and their positions in the reaction network. Since the hydrodenitrogenation reactions of indole and carbazole homologs were more difficult to carry out than the hydrodesulfurization reactions of benzothiophene and dibenzothiophene homologues, the denitrification rate was lower than the desulphurization rate at the outlet of the hydrotreating section. When the reaction temperature of the hydrotreating section was 360 °C, the conversion rates of sulfides and nitrides were 98.4 % and 91.3 %, respectively. The increase of reaction temperature intensified the hydrogenation saturation of aromatics, the ring opening of naphthenes and the cracking of paraffins. As the reaction temperature of the hydrocracking section rose from 370 °C to 410 °C, more isomerized carbon ions were generated due to the β-position cracking of paraffins. The mass ratio of methylbutane to n-pentane in light naphtha increased from 1.29 to 3.08. The increase of reaction temperature accelerated the side chain cracking reactions of naphthenes with 4 or more carbon atoms in the side chains, and generates more naphthenes with 0 to 3 carbon atoms in the side chains. Aromatics mainly underwent the ring-by-ring hydrogenation saturation reactions in the hydrotreating section, and bicyclic aromatic hydrocarbons was significantly easier to be hydrogenated than monocyclic aromatic hydrocarbons.

Influence of Acid Additives on Catalytic Cracking of Model Compounds System Containing Nitrogen

Evaluation of Strongly Acidic Ion-Exchange Catalysts and the Desulfonation Study in the Isobutylene Dimerization Reaction

Modeling and Optimization of Ethane Steam Cracking Process in An Industrial Tubular Reactor with Improved Reaction Scheme

An Insight into Effect of Methanol on Catalytic Behavior of Amberlyst 35 Resins for Alkylation Desulfurization of Fluid Catalytic Cracking Gasoline

IMPACT OF ADDITIONAL CATALYSTS ON NITROGEN DISTRIBUTION IN RESIDUE OIL SLURRY-BED HYDROCRACKING

The effect of acid strength on the mechanism of catalytic pyrolysis reaction of n-hexane in ZSM5: A DFT Study

Catalytic Mechanism of MCM-41 Supported Phosphoric Acid Catalyst for FCC Gasoline Desulfurization by Alkylation: Experimental and Theoretical Investigation

Improvement of Residue by Hydrocracking with Solid Acid,solid Base and Radical Initiators

The Influence of External Acid Strength of Hierarchical ZSM-5 Zeolites on N-Heptane Catalytic Cracking

Effect of Methanol on Catalytic Performance of Hy Zeolite for Desulfurization of Fcc Gasoline by Alkylation

Effects of post treatment of HZSM-5 zeolites on catalytic cracking of butene

Effects of Metal and Acidic Sites on the Reaction By-Products of Butyl Acetate Oxidation over Palladium-Based Catalysts

Effect of Acetic Anhydride on the Oxidation of Toluene to Benzaldehyde with Metal/Bromide Catalysts

High Metal–Acid Balance and Selective Hydrogenation Activity Catalysts for Hydrocracking of 1-Methylnaphthalene to Benzene, Toluene, and Xylene

Effect of Catalyst on Distribution of Nitrogen in Products from Residue Hydrocracking

Synergetic Regulation of the Microstructure and Acidity of HZSM-5/MCM-41 for Efficient Catalytic Cracking of n-Decane

Effects of Solid Acid and Alkali Catalysts on Catalytic Cracking of Biomass Tar

EFFECT OF ORGANIC ACIDS ON THE PROPERTIES OF NiW/Al2O3 HYDRODESULFURIZATION CATALYSTS

Study on Catalytic Cracking Reaction of Alkanes with Different Structures

Insight into the Role of Additives in Catalytic Synthesis of Cyclohexylamine from Nitrobenzene: Insight into the Role of Additives in Catalytic Synthesis of Cyclohexylamine from Nitrobenzene

Reaction laws of polycyclic aromatic hydrocarbons and heteroatomic compounds in hydrocracking process