Abstract:Fluid-to-fluid scaling for supercritical heat transfer can effectively reduce the difficulty and cost of heat transfer experiments in supercritical boilers and supercritical water reactors and can reduce the number of experiments by converting experimental data of the model fluid to the prototype fluid in organic Rankine cycles. Currently, most existing scaling methods are only suitable for forced convection, while few are developed for mixed convection where buoyancy significantly affects the heat transfer. This paper attempts to extend the applicability of scaling method to mixed convection with the aid of computational fluid dynamic simulations. The scaling parameters were analyzed first and then the shear-stress transport k- model was used to analyze the supercritical heat transfer characteristics of water and R134a to provide further information for developing a dimensionless number. The results show that significant variations of properties and flow parameters occur in the layer of y(+)=5 to 100 and the axial velocity gradient in this layer changes in quite a similar manner to the wall temperature. Based on numerical results, the axial velocity gradient was used with a thermal resistance analogy to derive a new dimensionless number, Re-A(-0.9), to scale the mass flux. Then, a set of fluid-to-fluid scaling laws were developed to predict the heat transfer to supercritical fluids. To validate the newly proposed scaling laws, well-developed correlations were used for forced convection flow and a direct validation method was developed for buoyancy-influenced flow. Results show that this new scaling method exhibits reasonable accuracy for both forced and mixed convection heat transfer with supercritical fluids.

Calculation Model for Convective Heat Transfer of Supercritical Fluids by Low Reynolds Number Κ-Ε Model

Reference temperature correction and dimensionless number analysis for heat transfer of supercritical CO2 in horizontal tubes

A Modified Buoyancy Effect Correction Method on Turbulent Convection Heat Transfer of Supercritical Pressure Fluid Based on RANS Model

Investigation And Modeling Of The In-Tube Heat Transfer Of Fluids At Supercritical Pressure During Heating

Performance assessment of turbulence models in CFX for predicting heat transfer of supercritical water

Assessment Of Performance Of Turbulence Models Of Cfx In Predicting Supercritical Water Heat Transfer In A Vertical Tube

Validation and analyses of RANS CFD models for turbulent heat transfer of hydrocarbon fuels at supercritical pressures

Numerical Study of Deteriorated Convection Heat Transfer of Supercritical Fluid Flowing Through Vertical Mini Tube at Relatively Low Reynolds Numbers

Studies on the flow acceleration and bouyancy effects on the heat transfer to supercritical CO2 flowing through mini channel

Effect of Circumferential Flow Non-uniformity on the Temperature Distribution of Membrane Water Wall in Supercritical Boilers and Simplified Calculation Methods

Reynolds-Averaged Navier-Stokes Equations Describing Turbulent Flow and Heat Transfer Behavior for Supercritical Fluid

Fluid-to-fluid Scaling of Heat Transfer to Mixed Convection Flow of Supercritical Pressure Fluids

Numerical Investigation of Heat Transfer to Supercritical Pressure Water in Vertical Tube with Non-Uniform Heating Form

Numerical Investigation of Heat Transfer Characteristics of scCO2 Flowing in a Vertically-Upward Tube with High Mass Flux

Influence of various aspects of low Reynolds number k-ε turbulence models on predicting in-tube buoyancy affected heat transfer to supercritical pressure fluids

A Method of Extending Subcritical Heat Transfer Correlations to Supercritical Conditions

On the correlation of buoyancy-influenced turbulent convective heat transfer to fluids at supercritical pressure

Experimental and numerical investigation of convection heat transfer in transpiration cooling

Comparison Between Heat Transfer to Supercritical Water in A Smooth Tube and in an Internally Ribbed Tube

Dynamic Simulation Model with Virtual Interfaces of Supercritical Working Fluid Heat Exchanger Based on Moving Boundary Method

High‐heat Flux Flow and Heat Transfer Transitions in a Supercritical Loop: Numerical Verification and Correlation