PREPARATION OF AMINO-FUNCTIONALIZED POLYSTYRENE NANOPARTICLES BY PHOTOINITIATED EMULSION POLYMERIZATION

Zhang Jieyu,Liu Lianying,Yang Wantai
DOI: https://doi.org/10.3724/sp.j.1105.2010.09484
2010-01-01
Abstract:Amino-functionalized polystyrene nanoparticles were prepared by a facile approach. First, an amino functionalized monomer N-(3-aminopropy1)-p-vinylbenzylimine (CVPD) was synthesized by the displacement reaction of 4-vinylbenzy chloride and 1, 3-propane diamine between dichloromethane. Then the nano-latex of styrene and N-(3-aminopropyl)-p-vinylbenzylimine copolymer were synthesized by UV-induced emulsion polymerization with water-soluble 4-(2-hydroxyethoxy)phenyl-(2-hydroxy-2-propyl) ketone (Irgacure 2959) as the photo-initiator and cetyltrimethylammonium bromides (CTAB) as the surfactant. The surfactant amount is only 0. 1 wt% similar to 0. 8 wt% of the total system, much lower than that of micoemulsion polymerization system which is generally used to synthesize nanoparticles. The diameter and diameter distribution of the P (St-co-CVPD) nanoparticles were characterized by transmission electron microscopy (TEM) and dynamic light scattering (DLS). The amino groups of the copolymer were evident from Fourier transform infrared spectroscopy (FTIR) and nuclear magnetic resonance (NMR), and the quantity of the amino groups was calculated by ninhydrin reaction. The effects of St/CVPD ratios, initiator concentrations, surfactant concentrations and UV light intensity on the polymerization system were investigated, respectively. The results show that amino-functionalized polystyrene particles with diameters of 30 similar to 600 nm, and amino group contents of 1.2 x 10(-5) similar to 1. 6 x 10(-4) mol/g could be conveniently prepared by this method. The polymerization rate of this emulsion polymerization system is fast, and the monomer conversion can reach 80% within 60 min. The amino group content can be controlled by varying St/CVPD ratios. The particle size can be tuned by changing St/CVPD ratios, initiator concentrations, surfactant concentrations and UV light intensity.
What problem does this paper attempt to address?