Abstract:Notice of Retraction After careful and considered review of the content of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE's Publication Principles. We hereby retract the content of this paper. Reasonable effort should be made to remove all past references to this paper. The presenting author of this paper has the option to appeal this decision by contacting TPII@ieee.org. Based on the numerical instabilities such as checkerboards, mesh-dependence and gray regions in the topology optimization, the perimeter constraint of the nodal independent variable method with a variational upper bound is utilized; MAC matrix of model shape is introduced especially for overcoming the modal order change of model shape after every iteration from the topology variable change, to track and optimize the fixed order model shape. The independence sensitivity of modal damping ratio is analyzed using adjoint method. Furthermore, the design method of topology optimization using the nodal independence variable of constrained damping plate is given, and the most optimization topology configuration of constrained damping layer is obtained based on the method of independence mapping. As a whole, results indicate that the convergence of this method is good and the phenomena of numerical instability can be removed. In addition, it has strong feasibility and certain engineering practicability to use it in the optimization design of damping structure.

Notice of RetractionOptimization of Bionics Knee Joint Mechanism Structure

Notice of RetractionInverse Kinematics and Application of a Type of Motion Chain Based on Screw Theory and Analytic Geometry

Notice of Retraction an Improved Predictor-Corrector Procedure for the Dynamics of Geometrically Nonlinear Shell Structure

Notice of Retraction Kinematics, statics and performance atlas of a novel hydraulic fine blanking press based on parallel structure

Notice of Retraction Research on agile virtual enterprises selection and optimization in project management

Contact Biomechanical Responce of Bionic Joint for Biped Robot

Notice of Retraction Study on sustainable development thought in bionic urban design

Notice of Retraction Kinematics and dynamics analysis of compound pendulum jawbreaker based on UG

Notice of Retraction: Failure Mode Research of Hyperstatic Truss Structure Based on Ansys

Bio-Mimetic Joint Actuator Imitating the Function of Human Knee

Retracted: Optical Microscope Rehabilitation Nursing Study of Anterior Cruciate Ligament Injury through Lateral Knee Incision Based on Medical Internet of Things

Notice of RetractionMDO of the Drive Axle Based on Collaborative Optimization

Notice of Retraction Intellectualized design of truss structure based on similarity theorem

Notice of Retraction A Multi-Objective Optimization Strategy Based on Improved Taguchi Method and Its Application of Bridge Structures

Notice of Retraction Optimization on dynamic performance of constrained damping layer using nodal independent variable

Notice of Retraction Multidisciplinary Design Optimization Based on Physical Programming

Notice of Retraction Analysis of the root lock mechanism of the locked space deploying mast

Notice of Retraction Study and application of optimization design scheme of roadway bolt support parameter

Optimization and Dynamics of Six-bar Mechanism Bionic Knee

Retraction Notice to Influence of Nucleotomy on the Load Sharing in the Spinal Facet Joint under the Loading Scenarios of Different Human Postures.

Notice of Retraction Analysis of Multi-Body Systems with Revolute Joint Wear