Abstract:The protection of unearthed waterlogged archaeological artifacts is a heavy task when large-scale construction is carried out in today's China. Freeze drying offers an efficient way for preserving wooden artifacts. In order to rationally design the freeze drying process, thermophysical studies were carried out in this paper. The measurements of water vapor diffusion coefficient and thermal conductivity were made. The impacts of cooling velocity and grain orientation on effective diffusion coefficient of water vapor, D, in dried wood were investigated. At low cooling velocity, 0.2K/min, D was (4.8±0.4)×10−4m2/s in parallel grain direction, or (1.9±0.4)×10−4 m2/s in perpendicular grain direction; at higher cooling velocity, 3.0K/min, D was (4.3±0.2)×10−4m2/s in parallel grain direction, or (1.2±0.1)×10−4m2/s in perpendicular grain direction. The thermal conductivity of the dried sample was in the range of 0.78–1.06W/(m·K). With the values attained, one-dimensional pseudo-steady analysis were made for the primary drying process of a cylinder and a flat slab. It was found that the process was mass-transfer controlled and the difference between surface temperature and sublimation temperature was very limited. Thus only mass transfer equation needed to be solved with assumption of constant sublimation temperature. The primary drying of a two-dimensional object was also simulated to predict the time required. Monitoring the surface temperature of each artifact and handling artifacts with similar drying time in a batch are proposed for the freeze drying of archaeological artifacts. The freeze-dried wooden artifacts by the authors yielded very small deformations.

Optimization of process parameters for freeze-drying of Letinus edodes

Optimization of Ultrasonic-Assisted Freezing of Penaeus Chinensis by Response Surface Methodology

Vacuum Freeze-Drying of Soybean Phosphatidylcholine

Study on the Effect of Ultrasonic Assisted Freezing on the Ice Crystals and Water Changes in Penaeus chinensis

The freeze-drying performance under pressures from 1.325 to 101.325 kPa

Optimization of Microwave Vacuum Low-temperature Drying Process for Rehmannia Glutinosa Libosch Leaves Extract

Study on the response law between cooling rate and temperature with process parameters during vacuum freezing of liquid

Influence of the process parameters on the energy conservation and quality of the kiwi fruit subjected to vacuum freeze-drying

Optimization for vacuum belt drying process of Panax notoginseng extract

Optimization for Vacuum Belt Drying Process of Rehmannia Leaves Extract

Thermodynamic Analysis of a Freeze-Dryer Utilizing Hygroscopic Solution

Experimental Study on a Vacuum Freeze-drying with Radiation System

Modelling the primary drying stage of the spray freeze drying process based on the non-equilibrium formulation

Real-time observation of the freezing stage of the mannitol solution using high-resolution optical microscopy

Investigation of the effect of infrared and ultrasonic exposure on the kinetics of vacuum freeze-drying of polymeric materials. Part 1: Development of device and process control system

Studies on the Optimization of Pretreatment Technology for Lentinus Edodes Prefreezing Heating & Blanching

Optimization of Cold-Air Drying of Apostichopus japonicus and Comparison with Other Drying Methods

A Thermophysical Study on the Freeze Drying of Wooden Archaeological Artifacts

Experimental study on effect of drying air supply temperature on performance of a quasi-two-stage closed loop heat pump drying system for lentinus edodes

Study on quality change mechanism of green turnip slices during low pressure superheated steam drying based on sensitivity analysis method

Study on Designing and Manufacturing the DS-12 Freeze - Drying System Using Infrared Radiation Heating Process