Abstract:Real-time measurement of heavy oil production is critical to ensure stable production. Due to the complex kinematic characteristics of heavy oil, existing methods cannot accurately measure its flow rate and water cut. In this paper, a novel method is proposed to measure the high water-cut heavy oil flow by using the differential pressure of the two-phase swirling flow in the pipe. For the swirling flow in the pipe, the radial differential pressure and the axial differential pressure exist simultaneously, which are very sensitive to the flow rate and water cut. The formation mechanism of the two kinds of differential pressure is analyzed theoretically, and their relationship with flow rate and water cut is studied by experiment and numerical simulation. The measurement model of heavy oil–water two-phase flow on the above relations is validated by field experiments. The radial differential pressure is only related to the two-phase flow rate, varying exponentially with the flow rate when the oil viscosity is greater than 10 000 mPa s. This characteristic is very useful for the heavy oil–water two-phase flow measurement. The axial differential pressure decreases with the increase in water cut in cases of water cut <85%, while it increases with the water cut in cases of water cut >85%. With the increase in water cut, the ratio of axial differential pressure to radial differential pressure first decreases and then increases. The relative errors of the established measurement model for flow rate and water cut are 0.19%–17.92% and 0.21%–15.5%, respectively, and more than 70% of the measurements with a relative error of less than 10%. The study of the heavy oil–water two-phase flow measurement method can optimize the measurement cost and accelerate the process of intelligent oilfield construction.

Application of Wavelet Neural Network in Oil-Water Two-Phase Flow Soft-Measurement

Oil-water two-phase flow measurement based on a hybrid flowmeter and dominant phase identification

Oil-water two-phase flow measurement based on differential pressure

Monitoring System of Gas-Liquid Two-Phase Flow

Experimental Studies on the Measurement of Oil-water Two-phase Flow

Measurement of conditional phase shifts for quantum logic.

Application of Wavelets Transform to Analysis of Multiphase Flow

Application of Empirical Mode Decomposition and Wavelet Analysis to Small Channel Gas-Liquid Two-Phase Flow Pattern Identification

Soft Measurement of Water Content in Oil-Water Two-Phase Flow Based on RS-SVM Classifier and GA-NN Predictor

Mass Flow Measurement of Oil-Water Two-Phase Flow Based on Coriolis Flow Meter and SVM

Oil-Gas-Water Three-Phase Flow Measurement Based on the Theory of Partial Separation

Neural Networks Approach for Prediction of Gas–liquid Two-Phase Flow Pattern Based on Frequency Domain Analysis of Vortex Flowmeter Signals

Investigation of Oil-Air Two-Phase Mass Flow Rate Measurement Using Venturi and Void Fraction Sensor

Air–water two-phase flow measurement using a Venturi meter and an electrical resistance tomography sensor

New Measurement Method of Oil-Water Two-Phase Flow with High Water Holdup and Low Rate by Phase State Regulation

Soft measurement model for wet gas flow rate based on ultrasonic and differential pressure sensing

Measurement of Crude Oil Water Content Based on Cross-Correlation Method

Measurement of high water-cut heavy oil flow based on differential pressure of swirling flow

Oil Fraction Measurement of Nonuniform Dispersed Oil–Water Two-Phase Flow Based on Ultrasonic Attenuation

Oil-water two-phase flow velocity measurement with Continuous wave ultrasonic Doppler

Flow regime identification of oil-water two-phase flow based on HHT and SVM