Abstract:In order to study the characteristics of fire smoke spread and temperature distribution of a large indoor pedestrian street under different heat release rates and smoke exhaust modes, this paper focuses on the analysis of fire smoke spread, visibility, smoke temperature distribution and variation curves in an atrium. This paper uses a numerical simulation method to conduct research. PyroSim fire simulation software is used to calculate this project, which is based on a full-scale experimental design scheme. The numerical simulation results show that under the conditions of higher heat release rate, the smoke spread rate is greater than that under the conditions of lower heat release rate. Furthermore, the average temperature of smoke in the atrium is also greater, up to about 400 °C. The conditions of a higher heat release rate also show the characteristics of faster generation, faster spread and a larger volume of smoke. When the smoke exhaust system is turned on, the thickness of the smoke layer and the smoke temperature decrease. There then comes a situation where the stabile section of the fire ends in advance. The simulation results of vertical temperature distribution in an atrium can fit the modified McCaffrey plume model in any case. Under all cases, the smoke temperature reaches the maximum directly above the fire source. The horizontal dimensionless smoke temperature rises under the atrium roof, and decreases exponentially with the dimensionless distance from the fire source. The greater the heat release rate of fire source is, the smaller the attenuation coefficient is, with a more than 50% change. When the smoke exhaust system is turned on, the smoke flow accelerates and the smoke is cooled rapidly. Thus, the attenuation coefficient increases. Additionally, the effect of mechanical smoke exhaust is better than natural smoke exhaust, because mechanical smoke exhaust makes air flow and heat exchange more intense. The variation amplitudes of the attenuation coefficient under natural smoke exhaust and mechanical smoke exhaust are 13% and 22%, respectively.

The Characteristics of Smoke Spreading of Fires in a Flat Underground Building in Cities

Full-scale Experiments on Smoke Movement in a Two-Story Detached House with Two Horizontal Openings at the Lower-Floor Ceiling

Numerical Simulation of Fire Smoke Spread in a Super High-Rise Building for Different Fire Scenarios

Numerical Simulation on Smoke Temperature Distribution in a Large Indoor Pedestrian Street Fire

Numerical Investigation on Smoke Movement in a Large Space Building under Fire Scenarios

Computational Simulation of Smoke Temperature Diffusion in High-rise Buildings Fires

Investigation on Smoke Flow in Stairwells Induced by an Adjacent Compartment Fire in High Rise Buildings

Full-scale Experimental Study on Fire-Induced Smoke Movement and Control in an Underground Double-Island Subway Station

Numerical study on fire smoke control in underground commercial street

Experimental and Theoretical Investigation of Longitudinal Temperature Attenuation and Smoke Movement in Urban Utility Tunnel Fires

Smoke Movement under a Hot Air Layer in Large Space Fires in Summer

Full-scale experimental study on thermal smoke movement characteristics in an indoor pedestrian street

Computational simulation of smoke temperature diffusing in high-rise building fire

Study on Smoke Spread Characteristic in Urban Interval Tunnel Fire

Numerical Study on Smoke Diffusion and Smoke Control in Urban Underground Curved Tunnel

Smoke control in underground commercial building

Fire Experiment on Temperature Distribution in an Underground Vertical Car Park

The Impact of Air-Tightness on Smoke Transport During High-Rise Building Fires Under Low-Temperature Conditions

Numerical Study on Smoke Temperature Characteristics in T-shaped Bifurcated Tunnel Fires

Research of Fire and Smoke Development in Underground Garages

Full-scale Experimental Study on Fire-Induced Smoke Propagation in Large Underground Plant of Hydropower Station