Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Research for flow and heat transfer in solar driven air gap membrane distillation system

Improving the Performance of the Air Gap Membrane Distillation Process by Using A Supplementary Vacuum Pump

Research on the Performance and Computational Fluid Dynamics Numerical Simulation of Plate Air Gap Membrane Distillation Module

Enhanced air gap membrane desalination by novel finned tubular membrane modules

Numerical Simulation and Optimal Design of AGMD-Based Hollow Fiber Modules for Desalination

Computational fluid dynamics simulation of the stacked module in air gap membrane distillation for enhanced permeate flux and energy efficiency

Simulation of Flow and Heat Transfer in Micro Couette Flow

Theoretical and experimental analysis of multi-effect air gap membrane distillation process (ME-AGMD)

Air-gap diffusion distillation: Theory and experiment

Air Gap Diffusion Distillation: A New Method for Solution Separation Technology

Analysis of the mechanism of enhanced heat transfer by nanofluids

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Experimental and Simulation Study of Solar-Powered Air-Gap Membrane Distillation Technology for Water Desalination

Effect of highly saturated superhydrophilic porous media on air gap diffusion distillation considering preferential flow

Numerical Study of Heat Transfer Characteristics in Bog Heat Exchanger

Experimental and simulation study of an air gap membrane distillation module with solar absorption function for desalination

Solar Energy Driven Membrane Desalination: Experimental Heat Transfer Analysis

Heat and Mass Transfer Evaluation of Air-Gap Diffusion Distillation by Ε-Ntu Method

Experimental and theoretical investigation on water desalination using air gap membrane distillation

Finned Tubular Air Gap Membrane Distillation

Air gap membrane distillation: A detailed study of high saline solution