Abstract:Abstract The two-dimensional (2D) system analysis codes are usually used to design and analyze the modular pebble-bed High Temperature Gas-cooled Reactors (HTR). However, in some cases, three-dimensional (3D) characteristics, for example the 3D power distribution and temperature distribution due to a part of control rods movement, also need to be concerned. In this paper, based on the 200 MWe Pebble-bed Modular High Temperature gas-cooled Reactor (HTR-PM) design, a 3D system analysis code was used to analyze some three-dimensional characteristics in steady state, as well as the transient process caused by the asymmetric movement of control rods in the side reflectors. Under normal operations of HTR-PM, the control rods are inserted at certain heights and the primary coolant enters the Reactor Pressure Vessel (RPV) from the outer pipe of the coaxial hot gas duct. As a result, the fuel temperature has a relative circumferential deviation of about 1.64% on the outside of the pebble bed, while a very small deviation at the center of the bed. The temperature distribution of RPV is significantly affected by the position of the helium inlet as well. The analysis results showed that, during the transient process caused by the withdrawal of two control rods, the relative circumferential deviation of the fuel particle temperature on the outside of the pebble bed would increase to around 8.47%. However, because of heat conduction in relatively long distance, the movement of the control rods has very little effect on the circumferential temperature deviation of the fuel particles at the center of the bed. These 3D characteristics of HTR under different conditions demonstrate the good applicability of 2D and 3D system codes and will provide support for more accurate safety analyses in the future.

Discontinuity Factor Applied in Three-Dimensional Diffusion Calculation for High-Temperature Gas-Cooled Reactor

Calculation and Application of Discontinuity Factors in Control Rod Region for High Temperature Gas-Cooled Reactor

Application of the Discontinuity Factor Theory to Accelerate Routine Rod Worth Calculations for Modular HTRs

Improvement of Discontinuity Factor for Strong Absorber Region

Reactor Core Homogenization in Transport Method

Analysis Of Heterogeneous Cores Using Sn Code With Discontinuity Factor

Equivalence of control rod model in high temperature gas-cooled reactor

Reactor Core Physics Simulation Method for Htr

Preliminary Study on Three-Dimensional Characteristics of Modular High Temperature Gas-Cooled Reactor

A CFD Method for Thermal-Hydraulic Calculation of Pebble Bed HTGRs

The improvement of the method of equivalent cross section in HTR

Improved Methods for Calculating the Neutron Diffusion Coefficient of General Pebble Bed

Analysis of Diffusion Process and Influence Factors in the Air Ingress Accident of the HTR-PM

Research on simulation of hydrogen diffusion behavior based on CONTHAC-3D code

On the diffusion coefficient calculation in two-step light water reactor core analysis

Data processing method for effective thermal diffusivity experiment of pebble bed in high temperature gas cooled reactors

Analysis of the 3D Neutron Kinetics for MHTGR

Numerical simulation of three dimensional unsteady process of hydrogen diffusion in nuclear reactor containment

High-Fidelity Neutron Transport Solution of High Temperature Gas-Cooled Reactor by Three-Dimensional Linear Source Method of Characteristics

A new method for solving the fission gas diffusion equations with time-varying diffusion coefficient and source term considering recrystallization of fuel grains

The Neutron Streaming Correction Method in the Homogenization of Pebble-bed HTGR Reflector