Abstract:A method of dynamic homogenization was recently proposed as an alternative technique for three-dimensional (3D) core calculations using a direct approach. This technique allows for producing homogenization parameters for a subdomain within the core at its actual state, and offers the advantage of avoiding off-line calculations, cross-section interpolations, and expensive 3D transport calculations. The methodology has shown a remarkable reduction in computational cost compared to 3D transport. However, the application of direct calculation schemes in multiphysics and multicycle problems still demands an extensive use of computational resources. Within the framework of traditional two-step calculations, several multilevel schemes have been developed to accelerate lattice calculations for the generation of the multiparameter cross-section libraries. With a similar objective, this work investigates how the multilevel approach can be applied within the framework of direct calculation schemes and discusses how depletion calculations may be performed. The objective is to enhance their performance and reduce memory requirements in favor of a high-fidelity model of the matter behavior in the reactor. We have then identified suitable flux solvers for each level and explored various homogenization options. We tested the methodology in a 3D pressurized water reactor core problem inspired by the TVA Watts Bar Unit 1 Multi-Physics Multi-Cycle OECD/NEA Benchmark, and performed a comparative analysis to assess the accuracy and computational efficiency of these new calculation schemes against direct single-level calculations and a two-step calculation based on pin-by-pin homogenization, as well as Monte Carlo simulations. Our analysis proves that the computational resources required to solve the full-core problem using a multilevel scheme are significantly reduced, and the best computational features are provided by multilevel dynamic homogenization. Furthermore, we observed that the multilevel approach not only allows for speedup, but can also be advantageously applied in order to improve the accuracy of the final solution of a calculation scheme when the core solver relies on an approximate transport operator.

Reactor Core Homogenization in Transport Method

Analysis Of Heterogeneous Cores Using Sn Code With Discontinuity Factor

Calculation and Application of Discontinuity Factors in Control Rod Region for High Temperature Gas-Cooled Reactor

Improvement of Discontinuity Factor for Strong Absorber Region

Discontinuity Factor Applied in Three-Dimensional Diffusion Calculation for High-Temperature Gas-Cooled Reactor

Application of the Discontinuity Factor Theory to Accelerate Routine Rod Worth Calculations for Modular HTRs

The two-dimensional heterogeneous modeling for non-isothermal non-adiabatic fixed-bed reactor and the analysis by orthogonal collocation

Continuous energy Monte Carlo method based homogenization multi-group constants calculation

Application of Homogenization Techniques for Inflow Transport Approximation on Light Water Reactor Analysis

An Equivalent Homogenization Method for Treating the Stochastic Media

The Neutron Streaming Correction Method in the Homogenization of Pebble-bed HTGR Reflector

Research on the On-the-fly Homogenization Method Based on RMC Code for Criticality Calculations

Improved Methods for Calculating the Neutron Diffusion Coefficient of General Pebble Bed

Application of neutron current method for Dancoff factor estimation of fuel particles in double-heterogeneous fuel

A Multilevel Approach for Direct Core Calculation Schemes

Verification of On-the-fly Homogenization Method Based on the Analysis of HTTR

The improvement of the method of equivalent cross section in HTR

Equivalence of control rod model in high temperature gas-cooled reactor

The Super Equivalence Method in Monte Carlo Based Homogenization

Reactor Core Physics Simulation Method for Htr

One-step Monte Carlo Global Homogenization Based on RMC Code