Experimental and Numerical Modeling Investigation on Purification Process of Phosphorus by Zone Melting

Yong-sheng REN,Jun LI,Rui MA,Jie-lin XU

DOI: https://doi.org/10.3321/j.issn:1003-9015.2009.06.005

2009-01-01

Abstract:In order to meet the demand of high-pure phosphoric acid and semiconductor industries, a combined theoretical and experimental approach was undertaken to find out the influences of zone length and times of zone pass on the solute distribution in ingot after the purification process of industrial yellow phosphorus by zone melting method. A numerical model was provided to predict the solute redistribution at any position of the ingot. The experimental results indicate that purifying phosphorus by zone melting method is appropriate, and the analysis results of the ICP-MS (inductively coupled plasma mass spectrometry) show that the removal results of the targeted 13 impurity ions (Fe, Ca, Co, Mg, Cr, Cd. Mn, Ni, Cu, Pb, Zn, Al, As) are satisfactory. Through the comparison of the experimental results with the theoretical predictions, it shows that the numerical model proposed can be used to predict the solute concentration distribution in ingot after zone melting process. The experimental results also indicate that, using purification process of zone melting, the purity of 60% product yellow phosphorus could easily reach higher than 99.99999% after 10 zone passes with zone length of 10% ingot length and travel rate of 5 mm·h~(-1).