Abstract:Three-dimensional numerical simulation on the waveguide formation written directly by 320nm ultraviolet laser in congruent lithium niobate (LN) crystal is presented. With the recent development of praseodymium (Pr)-doped laser crystal, the 320 nm UV laser has become easily available today. Though the absorption coefficient of this wavelength laser in LN is relatively low at room temperature, which might deter the direct waveguide writing fabrication, the situation will be much different when temperature rises. The absorption coefficient of this laser in LN will increase significantly under elevated temperature. When the temperature-dependent absorption coefficient is taken into consideration, the coupling of temperature and absorbed laser power will bring about interesting absorption characteristics. That is, the penetration depth of the laser will be affected by its power and the focus condition. In this work, we investigate the waveguide formation process in heated LN crystal via the lithium ion thermal-diffusion model. Cases where the laser is focused onto the surface and into the crystal are studied separately. The results show that when extra heated, the LN crystal can strongly absorb the 320nm laser focused on the surface and then form surface waveguides. Besides, when focused into the crystal, the laser will penetrate into the crystal and create internal high-temperature area with appropriated power and focusing parameter. However, in this case, only a relatively small refractive index change is obtained, which is not large enough to support efficient waveguide mode.

Thermal-Induced Refractive-Index Planar Waveguide Laser

An End-Pumped Nd:YAG Planar Waveguide Laser with an Optical to Optical Conversion Efficiency of 58%

Planar waveguide nanolaser configured by dye-doped hybrid nanofilm on substrate

Edge-bevel-pumped thermally bonded planar waveguide solid-state laser

A chamfered-edge-pumped planar waveguide solid-state laser

Quasi-self-imaging Planar Waveguide Lasers with High-Power Single-Mode Output

High power planar waveguide solid-state lasers with gain control

Low-repetition rate femtosecond laser writing of optical waveguides in KTP crystals: analysis of anisotropic refractive index changes

Monolithic Chalcogenide Glass Waveguide Integrated Interband Cascaded Laser

High-power Nd:YAG Planar Waveguide Laser with YAG and Al2O3 Claddings

Low-Dose Ion Implanted Active Waveguides in Nd3+ Doped Near-Stoichiometric Lithium Niobate: Promising Candidates for Near Infrared Integrated Laser

Laser action from a femtosecond laser written Yb: phosphate glass waveguide

Three-dimensional Numerical Simulation on the Directly Written Waveguide Formation with 320 Nm UV Laser in Lithium Niobate

Thermal-Induced Birefringence-Compensated Laser System with Two Nd∶ YAG Rods

Achievement of an Efficient 1053 Nm Nd:YLF Polarized Laser Based on Different Thermal Lensing Effects

High Power Planar Waveguide Solid-State Lasers With Gain Control - Art. No. 60280b

Boosting Continuous‐Wave Laser‐Driven Nonlinear Photothermal White Light Generation by Nanoscale Porosity

Numerical modelling and optimization of actively Q-switched waveguide lasers based on liquid crystal transducers

Preparation and characteristics of the O3+-ion-implanted and femtosecond laser-ablated waveguide in the high-gain Nd3+-doped laser glass

Refractive index modulation of YAG crystal through electronic energy depositions of argon ions

Study of light-absorbing crystal birefringence and electrical modulation mechanisms for coupled thermal-optical effects.