Abstract:Hot extrusion (HE) was applied in the treatment of low-cost commercial Al6063 alloy containing impurity iron (Fe) element (0.12 wt%) with the aim of decreasing the self-corrosion and optimizing the discharge performance of Al6063 alloy as an anode for Al-air battery. Experimental results showed that HE effectively refined the alpha-Al grains as well as the coarse AlFeSi phase along the grain boundaries and further led to the intragranular distribution of AlFeSi phase. The electrochemical tests proved that the corrosion resistance of Al alloy after HE treatment was enhanced. Combined with the surface analysis of Al anode after discharge, the immersion test suggested that the corrosion pits were prone to occur near the AlFeSi phase rather than at the grain boundaries and the distribution of AlFeSi phase at grain boundaries could accelerate the corrosion process, indicating that the HE induced improvement in corrosion resistance of Al alloy was attributed to fragmentation of AlFeSi phase and its distribution within grains from grain boundaries. Furthermore, owing to the increased grain boundaries and delayed corrosion process, the average discharge potential of Al anode increased from 1.1737 V to 1.1914 V while the energy density as well as the anode efficiency of which were improved by 65.39% and 62.95%, respectively. This research provided an effective approach to the expansion usage of low-cost commercial Al alloys as the potential anode materials for Al-air batteries.

Influence of Heat Treatment on Elements Distribution and Electrochemical Properties of Al-Zn-In Anode

Effects of Heat Treatment on Microstructure and Electrochemical Performance of Al-Zn-Sn-Ga Alloy

Effects of heat-treatment temperature on microstructure and electrochemical properties of AB5 type MlNi 3.60Co 0.85Mn 0.40Al 0.15 hydride electrode alloy

Research Status Quo of Heat Treatment to Aluminum Alloy Electrode for Battery

Influences of Heat Treatment on Electrochemical Performances and Corrosion Behaviors of Mg-Al-Pb Anodes

Effects of Heat Treatments on Phase Structure of Electrodeposition Aluminum Coatings on Different Substrates

Effects of heat treatment on the performance of aluminum anode in KOH solutions

Enhancing the Electrochemical Performance of Al-Mg-Sn-Ga Alloy Anode for Al-Air Battery by Solution Treatment

Effect of Heat Treatment on Mechanical Properties and Microstructures of 925ag Alloys of Ag-Cu-Zn(-Sn) System

Effect of solution treatment on microstructure and properties of Mg-6Al-5Pb-1Zn-0.3Mn anode

Influence of Heat Treatments on Organization and Performance of High-Strength Deformation Zinc Alloy

Effects of Thermal-Mechanical Treatment on Microstructure and Properties of Cu-Zn-Fe Alloy

Effect of Heat Treatment on Ni-Zn-P Alloy Property

Influence of Heat Treatment Condition on the Microstructure, Microhardness and Corrosion Resistance of Ag-Sn-In-Ni-Te Alloy Wire

Influence of Zn content on the microstructure and properties of as-annealed Al-Mn-Si alloys

Influence of Cyclic Non-Isothermal Heat Treatment on Microstructure, Mechanical Property and Corrosion Behavior of Al–Zn–Mg Alloy

Influence of Alloying Elements on Electrochemical Behavior and Microstructure of Al Anode Materials

The Role of Hot Extrusion in Improving Electrochemical Properties of Low-Cost Commercial Al Alloy As Anode for Al-air Battery

Effects of Alloying Elements on Electrochemical Performance of Aluminum Anodes

Effect of Heat Treatment on Corrosion Behaviors of Mg-5Y- 2Nd-3Sm-0.5zr Alloys

Effect of Annealing on Performance of Al Alloy Anodes Prepared by Different Rolling Technologies