Abstract:An Al(OH)(3)center dot Cr(OH)(3) nanoparticle preparation procedure and its catalytic effect and mechanism on thermal decomposition of ammonium perchlorate (AP) were investigated using transmission electron microscopy (TEM), X-ray diffraction (XRD), thermogravimetric analysis and differential scanning calorimetry (TG-DSC), X-ray photoelectron spectroscopy (XPS), and thermogravimetric analysis and mass spectroscopy (TG-MS). In the preparation procedure, TEM, SAED, and FT-IR showed that the Al(OH)(3)center dot Cr(OH)(3) particles were amorphous particles with dimensions in the nanometer size regime containing a large amount of surface hydroxyl under the controllable preparation conditions. When the Al(OH)(3)center dot Cr(OH)(3) nanoparticles were used as additives for the thermal decomposition of AP, the TG-DSC results showed that the addition of Al(OH)(3)center dot Cr(OH)(3) nanoparticles to AP remarkably decreased the onset temperature of AP decomposition from approximately 450 degrees C to 245 degrees C. The FT-IR, RS and XPS results confirmed that the surface hydroxyl content of the Al(OH)(3)center dot Cr(OH)(3) nanoparticles decreased from 67.94% to 63.65%, and Al(OH)(3)center dot Cr(OH)(3) nanoparticles were limitedly transformed from amorphous to crystalline after used as additives for the thermal decomposition of AP. Such behavior of Al(OH)(3)center dot Cr(OH)(3) nanoparticles promoted the oxidation of NH3 of AP to decompose to N2O first, as indicated by the TG-MS results, accelerating the AP thermal decomposition. (C) 2014 Elsevier B.V. All rights reserved.

Influence of Ammonium Chloride on Preparation of Α-Al2o3 Nanopowder by Thermal Decomposition of Ammonium Aluminum Carbonate Hydroxide

Study on the Synthesis of Nano Ammonium Aluminum Carbonate Hydroxide (AACH)

Preparation of Ultrafine Α-Al2o3 Powders by Thermal Decomposition of AACH

The Effect of Different Heating Modes for Ammonium Aluminium Carbonate Hydroxide on the Synthesis of Α-Al2o3 Nanopowders

Fabrication of Ultrafine Α-Al2o3 Powders by Thermal Decomposition of AACH

Effect of NH4Cl on the a phase transformation of Al2O3 derived from ammonium aluminum carbonate hydroxide

Preparation of Disperse Cake-like Α-Al2o3 Powder by AACH Method

Preparing Ultrafine Alumina Powder by AACH Thermal Decomposition

Hydrothermal Synthesis of Ammonium Aluminum Carbonate Hydroxide (AACH) Nanoplatelets and Nanofibers Ph-Controlled Morphologies

PREPARE ULTRAFINE α-Al2O3 POWDER BY PRECIPITATION METHOD

Effect of Aluminum Morphology on Thermal Decomposition of Ammonium Perchlorate

Preparation of Ultrafine Α -Al 2 O 3 Using Precipitation-Azeotropic Distillation Method

Preparation of Ultrafine Α-Al2o3 Powders by Catalytic Sintering of Ammonium Aluminum Carbonate Hydroxide at Low Temperature

An Experimental Study on the Preparation of Ultrafine Flake Α-Al2o3

Preparation of Nano-aluminum Powder in AlCl3-EMIC Ionic Liquid

Preparation of Nanocrystalline Co3O4 and Its Catalytic Performance for Thermal Decomposition of Ammonium Perchlorate

PREPARATION OF NANOMETER SIZE α-Fe2O3 AND ITS CATALYSIS ON THE THERMAL DECOMPOSITION OF AMMONIUM PERCHLORATE

Thermal Decomposition Of Ammonium Perchlorate In The Presence Of Al(Oh)(3)Center Dot Cr(Oh)(3) Nanoparticles

A New Homogeneous Precipitation Route to Ammonium Aluminum Carbonate Hydroxide

Effects of Drying Method on Preparation of Nanometer Α-Al 2 O 3

Properties and Characterization of Nano-alumina Powders Precipitated by Ammonium Bicarbonate