Precipitation of New Cubic Phase in Al-Li Alloys and Its Mechanism

王东林,李世晨,王小宁,郑子樵
DOI: https://doi.org/10.3321/j.issn:1004-0609.2009.12.008
2009-01-01
The Chinese Journal of Nonferrous Metals
Abstract:The Al-Cu-Li alloys with addition of trace elements of Mg and Zn,treated by T6(solution treatment+artificial aging)and T8(solution treatment+pre-deformation+artificial aging),were studied.The experiment results show that a lot of new cubic phases precipitate when the alloy is aged under the peak-aged condition of(T6,170 ℃),but this case dose not be found in the alloys aged under the peak-aged conditions of(T6,120 ℃) and(T6,190 ℃).There exists a competitive precipitation relationship between T1 phase and cubic phase,which is restricted by the factors of temperature and pre-deformation.Monte Carlo method was used to simulate the atom distribution in the alloy during initial aging stage and analyze the forming mechanism of the cubic phase.The simulation results show that during the initial aging stage of(T6,170 ℃),the Cu-Mg atom enrichment zones around Mg-Zn clusters become the perfect nucleate points for the cubic phase formation.Meanwhile,the higher vacancy concentration around Mg clusters is beneficial to quick solute diffusion.Thus,the Mg-Zn atom clusters may be the key factor of the formation of cubic phase.
What problem does this paper attempt to address?